Do gas dryers have thermal fuses?

Do gas dryers have thermal fuses?

The thermal fuse is a safety device that trips if the air flowing through the dryer begins to overheat. A blocked exhaust vent is the most common reason the air overheats. When a gas dryer thermal fuse blows, the drive motor runs but the burner won’t ignite.

Will dryer heat with blown thermal fuse?

A gas dryer will run but won’t heat if its thermal fuse blows because the dryer overheated (usually because the vent is clogged, so check the vent path). Use a multimeter to check the thermal fuse and replace the thermal fuse if you don’t’ measure continuity.

Can you run a dryer without a thermal fuse?

Operating a dryer with a bypassed thermal fuse is both unnecessary and unsafe, so a bypass should only be done long enough to troubleshoot a potential problem. Even short usage without a thermal fuse in place could result in irreparable damage to the appliance or injury to yourself.

How do you reset a Whirlpool gas dryer?

If your Whirlpool dryer displays a “PF” error code, indicating a recent power failure, the dryer will need to be reset and restarted. This is done by pressing “Start” for a few seconds to restart the dryer. If the dryer does not restart automatically, select a new cycle and any options then press “Start” to begin.

What will dryer do if thermal fuse is blown?

When it blows, the dryer stops generating heat. It’s necessary to replace it before the dryer will run again. The thermal fuse is different from the thermal cutoff. The thermal fuse stops the dryer from operating, tumble and heat included.

Can you bypass a thermal fuse on a gas dryer?

Unplug the dryer to disconnect electrical power. Temporarily tape the two wires that go to the thermal fuse together to essentially “bypass” or “jump” the thermal fuse. Use electrical tape to properly insulate the connection and avoid contact of bare wire contacts with the dryer cabinet.

What would cause a Whirlpool dryer not to heat?

If your Whirlpool dryer is not heating at all, one of the most common reasons is a fault with the heating element. The heating element consists of a coil of wire inside a metal chamber. If the coil breaks, the heating element will no longer heat and will need to be replaced.

What would cause a whirlpool dryer not to heat?

How much does a thermal fuse cost for a dryer?

Other Costs to Fix a Dryer