How do I program my gem remote?

How do I program my gem remote?

PROGRAMMING THE GEM TRANSMITTER: Press the learn button (inside the GEM box on dock) once and release. Press the down button 2 times on transmitter within 6 seconds of pressing learn. Your GEM Dock Unit can learn up to 16 transmitters.

How do you wire a gem remote?

Connect the red wire to contact labeled “Red”, connect the black wire to the contact labeled “Blk” and connect the orange wire to the contact labeled “orange”. Finally, connect the green wire from the motor to the green wire from the GEM control’s ground. Green wires must only be used as a ground.

How do you set auto stop on GEM remote?

Turn on power to the GEM unit and see that the LEDs on the top of the unit flash. 3. If the Auto-Stop LED at the top of the face card is on then press the Auto-Stop button and the LED will turn off. You want it off at this time.

Where should a boat sit on a boat lift?

Your watercraft should always be centered on your boat lift, which means a balanced front and back and even sides during elevation. If you place it too far forward or back, the other end becomes lighter, which makes it easier for it to come free and move with the help of the waves.

How do you adjust a gem remote limit switch?

Remove Yellow cap by removing 2 screws (these will be loose from GEM Remotes) Adjustment Procedures: To adjust the upper limit use screw 2o-2(blue wire on micro switch). To adjust the lower limit use screw 2o -1(red wire on micro switch). 10: Your lift should be at the max height if you followed the directions above.

Can you use a generator on a boat lift?

You can use a generator to power the lift (see Safe generator use), however, most generators have a low starting torque and the lift power draw will bog down a generator if it is not sufficiently sized. Your typical 1800 watt portable generator will not cut it.

Does a boat have to be centered on a lift?

Improperly Balancing Your Boat Your watercraft should always be centered on your boat lift, which means a balanced front and back and even sides during elevation. If you place it too far forward or back, the other end becomes lighter, which makes it easier for it to come free and move with the help of the waves.

Can you back into a boat lift?

1)Remove the lift, move the pilings back, and re-install the lift. 2)Try to back the boat in. There is plenty of water and more than enough cable to get the cradles down far enough to get the outboards over.

How do you reset a boat lift?

Turn the unit key in either direction to reset the unit. 3. Press and hold either the “Raise Boat” or “Lower Boat” button on the remote control and reconnect the power to the Boat Lift Boss unit. A properly programmed unit will begin operation as soon as power is restored.

How do you adjust a limit switch on a boat lift?

How much electricity does a boat lift use?

For boat lifts that operate with a ¾ horsepower motor at 110 Volts it will typically draw 12.5 Amps and at 220 Volts it will typically draw 7.5 Amps. For boat lifts that operate with a 1 horsepower motor at 110 Volts it will typically draw 14.5A and at 220 Volts it will typically draw 8.5 Amps.

How much power is needed for a boat lift?

220v
Right power for boat lifts When your lift motor has a 1 horsepower motor or larger, you need to supply 220v to ensure optimal performance. However, if your boat lift already has 110v, an inspection can show you if it’s capable of handling 20 amps @ 110v and if it can’t, then you need to upgrade to 220v.

How long do boat lift Motors last?

7-10 years
Make sure the top-side drain holes are closed, and the bottom-side drain holes are open to keep out debris and allow proper drainage. High-quality motors typically last 7-10 years under a cover.