What is the coating on drive shaft splines?
Table of Contents
What is the coating on drive shaft splines?
That “blue stuff” on the splines of the slip yoke is called Glidecote. The blue, nylon, wear-resistant coating on Spicer yoke shafts helps reduce vibration. The coating is machined on the splines for a tight fit.
Should you grease the splines on a drive shaft?
So initially, all you need to do is install it. Down the road however you will need to grease your drive shaft to ensure a long life. A good guideline to start with is to grease your shaft every oil change.
Why are splined drive shafts used?
Splined shafts are built to withstand high-speed rotation, with exceptional control and uniform load distribution across the entire spline groove. More evenly distributed force allows for more reliable load transmission and higher speeds without the risk for catastrophic part misalignments.
Should you put grease on axle splines?
When installing a CV shaft into a bearing hub assembly, we don’t recommend using any lubricant at all. Instead, just clean the shaft really well with a wire brush and make sure there’s no dirt or debris on the shaft or in the hub.
Do you put grease on CV axle splines?
Anti-seize is basically a type of grease and that is all. Use anti-seize or grease is fine.
What kind of grease do you use on a prop shaft?
If everything is in order, apply 2-4-C Marine Grease to all threads and splines on the prop shaft. Then reinstall the prop and hub kit. It’s that simple.
How often should you grease a drive shaft?
All shafts in storage should be re-lubricated every six months as part of an in storage maintenance program. Any shaft being pulled from storage and put into operation should be re-lubricated prior to being placed into operation. Care should be exercised when delivering shafts to the job site.
What is EP grease best used for?
EP grease is a grease designed for extreme pressure. Putting AP or MP grease in situations where the grease will be put under such high pressures may cause more wear to the machinery in the long run. However, EP grease can be used almost anywhere that AP or MP grease would be needed.
Can I use anti seize on axle splines?
Should you put anti seize on axle nut?
Anti Seize is not the recommended lubricant for it. But if you decide to use it anyway, make sure you use the Anti Seize correct for the material and function. Use the wrong one and you will have high wear or components will actually Seize.
What is spline grinding?
Gear grinding is basically the process of creating the teeth or splines on a gear. There are two processes utilized and each has its own costs and benefits. After formation of the gear splines, more refined gear grinding is done to polish and finish the gear’s surface.