What is S213 abend in mainframe?

What is S213 abend in mainframe?

An S213 abend or other OPEN failure may occur when message explanations are generated at the end of a Tivoli Advanced Catalog Management job step. This is replaced with a warning message that the libraries could not be opened. A similar message will be issued if the MSGLIB cannot be allocated.

What is abend S002?

And here is an explanation of the ABEND: S002 – 18 – AN INVALID RECORD WAS ENCOUNTERED ON A PUT OPERATION; THE DATASET USES THE VARIABLE RECORD FORMAT.

What is an abend code?

Abend Codes. An abend, or abnormal end, is the most obvious way for a software problem to be indicated. The z/OS processing for an abend normally creates a dump of the failing program’s address space storage for use in problem determination.

What is abend S013?

The S013 Abend occurs when the Program expects the DD to have a specific DCB, but the DD has a different DCB. Specify the correct DCB for the DD.

What is mainframe abend code?

An abend occurs when the host system cannot resolve an error condition generated by the program. The term’s origin is attributed to the IBM 360 operating system that ran on IBM mainframe computers in the 1960s and 1970s.

What is soc4 Abend?

S0C4 Abend is a protection exception when a virtual address cannot be mapped with a physical address. When S0C4 Abend occurs. An Invalid address referenced due to subscript error. In a group Move the length of the receiving field was defined incorrectly.

What is the difference between SB37 sd37 and SE37?

Thanks alot. SB37 when the dataset is out of secondary extended space, or even the the 15 secondary extended volume provided to you for each primary extended space is used up. SE37 is related to directory block, if there is no space for an extra member in the PDS. THE PDS NEED TO BE COMPRESSED.

What doe S222 mean?

S222 means job was cancelled by a user or operator without a dump. If a TSO session times. out you will probably get an S522 abend code.

How do I fix sb37 error?

Resolving The Problem If both the abend and the error message are encountered, increase the allocation for the output data set. When only the error message occurs, either specify 0 for LRECL and BLKSIZE or do not specify these parameters. Optim will determine the values to use at run time.