Can a garbage disposal switch be in the cabinet?

Can a garbage disposal switch be in the cabinet?

The electrical contractor mounted the switch inside the cabinet. So to turn the disposal on,you would have to open the cabinet door to turn the switch on. With Granite backsplashes in alot of high-end custom homes, this is not uncommon. Plugmold under the cabinets and disposal switch inside cabinet.

Does a Garburator need a switch?

Be aware that most types of disposals require a switch adjacent to the sink to control the outlet—the electrician should wire for this, too. Note: Batch-feed disposers don’t require a switch because they start when you insert and turn a special drain plug.

How far does the garbage disposal switch need to be from the sink?

The location of the disposal switch should be place where a disabled individual can’t turn it on accidently by bumping it with their wheelchair. The best location for a kitchen design would be to the left of the kitchen sink, a few inches below the over-hang of the kitchen counter, roughly at 28-30 inches in height.

Do garbage disposals need special switches?

Some garbage disposals run at 15 amps while others require a 20-amp circuit and switch. You should be able to find the switch you need in home centers and hardware stores in your area, if not online. All switches are not the same, and codes require disposal switches to have a marked off position.

How close can a switch be to a kitchen sink?

Additionally, no point on the wall should be farther than 24 inches from an outlet in either direction (meaning 4 feet total between outlets), so you must have an outlet within 2 feet of the kitchen sink.

Does a garbage disposal have to be GFCI protected?

The National Electrical Code (NEC) does not require a garbage disposal to have GFCI protection. GFCI protection for this appliance is optional. The vibration caused by the operation of a garbage disposal can cause electrical connections to separate.

What is an Airswitch?

As you may assume from the name, an Air Switch is a switch which is activated by air. A push button can be used to instigate a “puff” or “sip” of air which travels along a length of PVC tubing and activates the air switch. The air switch will turn a device on or off.

How does an air switch work for a garbage disposal?

A garbage disposal air switch is a type of pressure or plunger control knob that activates a garbage disposal by pushing a burst of air through a plastic or vinyl tube to a control unit mounted under a sink. These air switches do not rely upon electricity and thus permit mounting on counter or sink surfaces.

Do garbage disposals need a dedicated circuit?

Garbage disposals should be either hardwired or connected to an outlet through a grounded electrical outlet. A dedicated circuit is generally recommended, although a circuit that is shared with a dishwasher is sometimes appropriate.

Where should light switches be placed in a kitchen?

For light switches and garbage disposal switches that’ll be located above a kitchen counter, it’s standard practice to install them approximately 4 inches above the countertop. Since the standard height for most countertops is 36 inches, that places the bottom of the switch plate 40 inches from the floor.

Why does my garbage disposal trip the GFCI outlet?

The receptacle that the disposal is plugged into is fed from the Load side of the GFCI receptacle, thereby providing ground fault protection to the receptacle. There is a ground fault somewhere between the GFCI and the disposal, which is causing the GFCI to do it’s job and trip.