Where is the Page button on Ooma?

Where is the Page button on Ooma?

Page Key (on rear of Base Station) Press to locate your Ooma handsets. Press-and-hold for three seconds to register a new cordless Ooma device such as an HD2 Handset or Linx. Solid Blue System Status Indicates that your Ooma service is working.

What is the flash button on Ooma phone?

Switch to a second incoming call by pressing the Flash key on your telephone handset. The current call will automatically be put on hold. To switch back, press the Flash key again.

What does red mean on Ooma?

If the device has functioned in the past, the flashing red logo usually means that an interruption in your Internet service may have broken the device’s connection to Ooma servers. Verify that your Internet connection is functioning properly.

How do I reset my Ooma Base Station?

Connect a computer or router to the Base Station for additional setup options. Push down and hold for 10 seconds while plugged in to perform a factory reset of the device.

How do I answer my Ooma phone?

How to answer a phone call

1. Analog phone. You can answer a call by picking up the phone when it rings.
2. Ooma IP phone. Pick up the handset or press the Answer softkey or the speaker key when it rings.
3. Cisco or Yealink IP phone. Pick up the handset or press the speaker key when the phone rings.
4. Ooma DP1 desk phone.
5. Mobile app.

Why is Ooma blinking blue?

Plug in your Ooma Telo Plug the provided AC adapter Binto the POWER port. It is normal for the lights on the Telo to blink for a couple of minutes while it boots up. The light on top of the device will light up blue once the device is ready to be used.

Why is Ooma flashing purple?

If your device requires a software upgrade, the Ooma logo will blink purple while it is downloading the newest version. it is upgrading. It will automatically reboot after the upgrade is complete.

How do I reset Ooma after Internet outage?

Re: restart sequence after a power outage My cable modem, Ooma Hub, and router (which are connected in that sequence) are all plugged into the same power strip. To restart everything, I just kill the power strip, wait 5-10 seconds, and turn the power strip back on.

How do I reconnect my Ooma?

Ensure that your Ooma Wireless + Bluetooth Adapter is plugged in all the way. Remove your adapter, reboot your Telo Base Station, and then re-insert the adapter. Move the Telo Base Station closer to your router or wireless access point to make sure it is not out of range.

Where is the reset button on a Ooma Telo?

To reset the telo handset press the red button for about 3 seconds until the handset turns off. Next press the 0 and left softkey while pressing the red button briefly to power back on. The handset is now reset.

Is there a reset button on Ooma Telo?

How do I reset Ooma base station?

How do you answer the phone?

Learn how to check your Android version….Answer or reject a phone call

1. To answer the call, swipe the white circle to the top of the screen when your phone is locked, or tap Answer.
2. To reject the call, swipe the white circle to the bottom of the screen when your phone is locked, or tap Dismiss.

How do I use my Ooma phone?

1. When placing a call with your Ooma account, begin by launching the Ooma app. Then, dial the phone number using the app’s keypad.
2. To place a call using your device’s mobile number, you’ll start your call from your device’s “Phone” feature, not through the Ooma app.

What do the Ooma lights mean?

Solid blue light. Base Station is online and in service. Rapidly-blinking blue light. Base Station is in registration mode. Solid amber light.