What is the command to configure EIGRP?
Table of Contents
What is the command to configure EIGRP?
Configuring EIGRP 1 Only two steps are required: enabling EIGRP by using the router eigrp ASN_NUMBER command. telling EIGRP which networks to advertise by using one or more network statements.
How do I configure EIGRP and rip on the same network?
- Enter configuration commands, one per line. End with CNTL/Z. Router(config)#hostname R2.
- R2(config)#router rip. R2(config-router)#version 2. R2(config-router)#network 20.0.0.0.
- R2(config)#router eigrp 1. R2(config-router)#network 20.0.0.0.
- R2(config)#interface se0/0/1. R2(config-if)#ip address 30.0.0.1 255.0.0.0.
What is the command to invoke EIGRP?
You can use the “show ip route eigrp” command on the router to list all routes added in the routing table by EIGRP.
What is Cisco EIGRP?
Enhanced Interior Gateway Routing Protocol (EIGRP) is a network protocol that enables routers to exchange information more efficiently than earlier network protocols, such as Interior Gateway Routing Protocol (IGRP) or Border Gateway Protocol (BGP).
How do I configure RIP routing?
To configure a basic RIP network:
- Configure the network interfaces. This example shows multiple loopback interface addresses to simulate attached networks.
- Create the RIP group and add the interface.
- Create the routing policy to advertise both direct and RIP-learned routes.
- Apply the routing policy.
What is EIGRP protocol in networking?
When configuring EIGRP and you set an interface to passive what might occur?
Passive EIGRP interfaces do not send out or process EIGRP hellos, which prevents EIGRP from forming adjacencies on that interface. To configure an EIGRP interface as passive, you use the command passive-interface interface-id under the EIGRP process for classic configuration.
How does EIGRP work in networking?
The EIGRP transport mechanism uses a mix of multicast and unicast packets, using reliable delivery when necessary. All transmissions use IP with the protocol type field set to 88. The IP multicast address used is 224.0. 0.10 .
How EIGRP works in router devices?
An EIGRP-based router keeps a copy of its neighbor’s routing tables. If it can’t find a route to a destination in one of these tables, it queries its neighbors for a route, and they, in turn, query their neighbors until a route is found.
What command will display all connected EIGRP routers?
Verifying EIGRP
| Router#show ip eigrp neighbors | Displays the neighbor table. |
|---|---|
| Router#show ip eigrp neighbors detail | Displays a detailed neighbor table. |
| TIP The show ip eigrp neighbors detail command verifies whether a neighbor is configured as a stub router. | |
| Router#show ip eigrp interfaces | Shows information for each interface. |
What is Cisco Eigrp?
What command configures ripv2 on router?
On router R1, in the global configuration mode, enter the router rip command to enable RIP. In the RIP configuration mode, change the version of the protocol to 2 by using the version 2 command. Next, use the network 10.0. 0.0 command to include the Fa0/1 interface on the router R1 in the routing process.
Where is EIGRP protocol used?
It supports both IPV4 and IPV6 networks. It provides encryption for security and can be used with iBGP for WAN routing. Enhanced Interior Gateway Routing Protocol(EIGRP) is an advanced distance-vector routing protocol that is used on a computer network to help automate routing decisions and configuration.
