What size are Mazda 6 lug nuts?

What size are Mazda 6 lug nuts?

Dorman – Autograde – Wheel Nut M12-1.50 Standard – 21mm Hex, 18mm Length (sold by each) (Part No. 611-072)

What size lug nuts are on a 2005 Mazda 6?

Mazda 6 2005, Cone Seat Acorn Lug Nuts by Gorilla Automotive®. Thread Size: M12 x 1.5. Hex Size: 13/16″. Overall Length: 35.56 mm.

What size are Mazda lug nuts?

21mm
These wheel nuts are constructed to keep your wheels connected while providing dependability and strength. They are also known as lug nuts, and each one is manufactured for increased strength and uniformity. These are the OEM Mazda 21mm lug nuts.

What is a bolt or nut tightening sequence?

Tightening sequence. The first pass, lightly tighten the first bolt then move directly across or 180 degrees for the second bolt, then move1/4 turn around the circle or 90 degrees for the third bolt and directly across for the fourth. Continue this sequence until all bolts are tightened.

Is it OK to hand tighten lug nuts?

Can you over-tighten your lug nuts by hand? Sure you can. If it’s not just your car that’s jacked up. If you have the necessary muscle, you could tighten the nuts more than the specifications call for.

How many times should you click a torque wrench?

For accurate results, one click is enough Users often allow torque wrenches to click multiple times, without being aware of the additional torque being applied to the bolts. Operate your torque wrench in a smooth and steady manner and remember that one click is enough.

What size lug nuts are on a 2013 Mazda 6?

Dorman – Autograde – Wheel Nut M12-1.50 Acorn – 21mm Hex, 26mm Length (sold by each) (Part No. 611-141)

Are lug nuts metric or SAE?

You can get the lug nut’s thread size by measuring the diameter of the stud it matches. Since these measurements tend to be of small circular surfaces and need to be precise, dial or digital calipers are the best tools for the job. Your vehicle may use SAE or metric: Common SAE sizes are 7/16, 1/2, 9/16 and 5/8.

Should lug nuts be lubricated?

But experts tell us not to use any lubricant, including anti-seize compound, on wheel studs or nuts. The tech folks at Tire Rack state: “Torque specifications are for dry threads only. The fastener threads should be free of oil, dirt, grit, corrosion, etc. It is important NOT to lubricate hardware threads or seats.

Where do I find torque specs on my car?

The torque specs for the axle nut (and other nuts and bolts) should be listed in the dealership/shop guide provided by the manufacturer. If you can’t find that information, or if you don’t have a guide, you can find the specs in the service manual.