How do you reset the wind on a Raymarine?
Table of Contents
How do you reset the wind on a Raymarine?
Simultaneously press the press the POWER and TRUE/APP buttons and hold pressed for two seconds until you observe the instrument reset.
How do you test a Raymarine wind transducer?
Set the multimeter to the 20V DC scale. Test at the connections on the rear of the display head, or at the base of the mast (if you have a junction box installed), making sure that everything is connected and powered. – Red to shield should read 8V DC steady.
How do you calibrate a Raymarine ST60 wind?
Press the DISP button 4 times until the current wind speed is shown. once value is corrected, press and hold the DISP and TRUE/APP buttons exactly together for 2 seconds to exit calibration and store.
How do you calibrate Raymarine speed?
You just need to go into calibration mode by pressing the two left most buttons at the same time …. Depth and Speed …. and hold them for a few seconds. It can be quite tricky to time it but when you get it right it says CAL. Then press Speed to go through the speed options including calibration.
How long does it take for autopilot to calibrate?
Calibration typically completes after driving 20-25 miles (32-40 km), but the distance varies depending on road and environmental conditions.
How do you calibrate an autopilot salt system?
You MUST use a reliable test kit to verify the salt level….If the test result is different from the display, re calibrate (in 100 ppm increments) until the unit matches your test result.
- Press MENU button.
- Press Arrow UP to MAINTENANCE MENU, then press SELECT.
- Press Arrow UP to CALIBRATE SALT, then press SELECT.
Why does my spot lock turn off?
Spot lock keeps turning off When this problem occurs, it’s most often due to one of two causes: the GPS signal cutting out, or a faulty setting of the foot pedal. Check if there is any debris stuck under the foot pedal, or between the pedal and the recessed tray.
How long does a salt cell last?
about five years
This is all possible thanks to your pool’s salt chlorine generator cell. With proper care, a cell will last about five years. Eventually, though, it will need to be replaced. The trick is, it’s not always easy to know when it’s time.
How long does an autopilot salt cell last?
The good news about salt cells is that there is no shelf life. You could place a new salt cell in your garage today and it will be just as good 10 years later. There is no set amount of time a cell will last. This is a common misconception even among pool service techs.
Do I need the heading sensor for spot lock?
No, you don’t need the heading sensor for spot lock, since spot lock relies on the GPS coordinates measured by the i-Pilot controller, which is located inside the Control Head of the trolling motor.
