How do you measure a rivet nut?
Table of Contents
How do you measure a rivet nut?
Flat Head – the rivet nut body length (L) is always measured overall. Countersunk Head or Reduced Head – the rivet body length (L) is always measured from the top of the head to the end of the body.
What size is M6 rivnut?
40x M6 stainless steel rivet nut. Application Drill Hole Size: 0.354 inch / 9mm. Head Diameter.: 12.3mm ./ Head Height: 1.3mm. Total Length: 15.5mm ,/ Grip Range: 0.5-3.0 mm….Product Specifications.
| Ean | 0610600481392 |
|---|---|
| Part Number | 304-M6 |
| Size | M6 |
| Thread Pitch | m6 millimeters |
| Thread Size | m6 |
What size is M3 rivet nut?
Specification
| Diameter (d) | Length (L) | Grip Range |
|---|---|---|
| M3 | 9.0mm | 0.5 – 1.5mm |
| M3 | 9.5mm | 0.5 – 2.5mm |
What size hole do I drill for M5 rivnut?
Body
| Code | Size (D) (mm) | Hole Size (mm) |
|---|---|---|
| RIV-CSK | M4 | 6 |
| M5 | 7 | |
| M6 | 9 | |
| M8 | 11 |
How much can rivet nuts hold?
The cell holds up to 35 gallons. The fuel cell weighs roughly 225 pounds when full. I have been at some pretty crazy angles off road with fuel in the tank and have had zero issues. I have faith in my rivnuts, but I used a quality tool for installation.
How do you tighten loose rivets?
Place your piece of wood or metal over the rivet on the handle, and hammer hard a few times. Check and repeat as necessary to both rivets. The trick is to make sure there is a good back stop holding the interior rivet, and a piece to hold over the rivet itself on the handle before hammering the material tighter.
What size hole do I drill for a 6mm Rivnut?
M6 Rivet Nut, Countersunk, Steel, Grip range 1.50 – 4.0mm, Hole Size 9.1mm.
What is grip range for a rivet?
Grip Range – the rivet grip range refers to the total thickness of the materials to be joined. The grip range capability of each blind rivet is listed in a table see page 2. It is recommended practice to select a rivet with a grip range within the limits of the total material thickness. L.
What is rivet edge distance?
Edge distance is a term used in sheet metal aircraft construction. It refers to the distance from the center of a rivet to the edge of the material it is holding together. Edge Distance.
What size hole do you drill for 1/4 inch Rivnut?
Aluminum 1/4-20 rivet nuts body diameter:0.350″, application Hole Size:0.351″-0.356″, grip range:0.020″-0.120″.
What is the grip range on a Rivnut?
Rivet nuts typically can grip material thicknesses between 0.010” up to 0.500” thick, but no one rivet nut can cover that entire range!
