How much does a used driveshaft cost?

How much does a used driveshaft cost?

On average, you can expect to pay anywhere from $400 to $1,260 total but it can easily approach close to $2,000 for some vehicles. If you have a four-wheel drive vehicle, you may have two driveshafts but in most cases, only one will need to be replaced.

Is it hard to replace a driveshaft?

Changing a drive shaft is actually a simple task that a home mechanic can undertake without too much trepidation. It’s just a case of being thorough, being safe, and of course having your trusty Haynes Manual to hand.

How long does a drive shaft last?

about 75,000 miles
Is There a Set Lifespan? Because of the wide variety of drive shafts that exist, there is no average life expectancy that you can refer to for them. However, you can obtain a rough estimate for personal vehicles’ drive shafts, which is about 75,000 miles.

How many drive shafts in a car?

two driveshafts
On a typical four-wheel drive or all-wheel drive vehicle, there are two driveshafts. There is the same driveshaft that is on a rear-wheel drive car but there is also an additional front driveshaft that is connected to the front differential and the transfer case by u-joints.

Can I replace drive shaft myself?

Whatever your reason for needing a driveshaft replacement, if you’re handy, you may want to consider doing the job yourself. Replacing a driveshaft is usually a relatively straightforward affair if you have the tools and the know-how.

Should I replace both drive shafts?

On a high-mileage vehicle with a bad CV joint or boot, it’s often a good idea to replace both shafts at the same time. Often, the right (passenger side) shaft fails first because right turns are at a sharper angle than left turns, and right turns are more common than left turns.

When should I replace drive shaft?

While there is no set lifespan of a driveshaft, it typically can last about 75,000 miles. Keep in mind depending on the vehicle, and wear and tear you may get much less or much more.

Can you drive without a driveshaft?

Can you drive a 4WD truck without a front or rear driveshaft? Yes, this is possible, if you drive a traditional 4WD with a lockable center differential. Remove the damaged drive shaft and lock the center differential.

How long does it take to fit a drive shaft?

even a novice should have it done in about 2-3 hours taking your time and following the manual.

What happens if drive shaft breaks while driving?

If your driveshaft breaks while driving, then you can expect a lot of damage – to yourself, to other drivers, and to your car. The best way to avoid this is by having the drive shaft inspected regularly and making sure that all of the moving parts are in good condition.

How much should a driveshaft cost to replace?

In most cases, a new drive shaft costs somewhere between $300 and $1300. Fortunately, it only takes about an hour to replace it. A repair usually costs much less, around $200 to $300 including parts and labor, but this also depends on how many parts need to be replaced.

How much to expect a drive shaft to cost?

Drive Shaft Replacement Cost You can expect the parts cost to be anywhere from $320 to $750, while the labor costs are only around $150 to $190. If you have a rear wheel or four wheel drive vehicle which as a long drive shaft to power the rear wheels, then expect to pay somewhere in the range of $600 to $2,000.

How much does is the cost to replace a drive shaft?

The Average Drive shaft Replacement Cost. If you’re just replacing the drive shaft for your front wheels, then it will cost anywhere from $470 to $940 . You can expect the parts cost to be anywhere from $320 to $750 , while the labor costs are only around $150 to $190 .

How much is a drive shaft?

The cost of a drive shaft depends on the type of car you drive. Cars with a lot of power or large SUVs tend to have drive shafts that cost more than regular sedans or coupes. As a rough guide, a drive shaft costs between $300 and $1300.

How much free play should a drive shaft have?

How much does a driveshaft play cost? With the car’s weight on the tires, you should be able to take the rear u-joint loose and push the driveshaft forward about 3/4 of an inch until the yoke bottoms out. Any less than that and you risk bottoming the yoke on bumps. Any more than that and there is insufficient spline engagement to transfer power.