How do I know what size turntable belt I need?

How do I know what size turntable belt I need?

To select the correct size belt measure the diameter (the distance across not around) the subplatter. This will usually be in the range 140mm to 210mm. Then choose the belt size just below the measurement. eg if the diameter is 198mm, choose a 195 belt.

Are all turntable belts the same size?

Turntable belts construction is usually the same material, but they are not equal in size. These belts vary in thickness, length, and width; therefore, you can’t just install any belt in your turntable. In fact, each model has its specific replacement belt.

What belt do I need for turntable?

Almost all turntables use belts that have lengths of 19.6″, 20.7″, 21.4″, 22.4, 23.6″, 25.0″, and 35.1″. There are a few assorted turntables that use a couple of other sizes. BUT…. there is NO turntable ever made that uses a 23.2″, 24.75″ or 25.75″ belt.

How much does it cost to replace the belt on a turntable?

The more you use your record player, the quicker the belt will wear out, though most last for several years before becoming loose or becoming altogether inoperable. Most turntable replacement belts cost under $20, an inexpensive fix.

Can I use a rubber band for a turntable belt?

Belt drive turntables literally turn with the help of a belt made of rubber. So I searched through a 1/2 lb bag of various sized rubber bands that I had bought from a local office supply store and found several large bands and tried one on the turntable and to my surprise it worked.

What do the numbers on drive belts mean?

The first one, and the more recognizable one, is the manufacturer’s part number, which is referenced when ordering the part. The second, and lesser known one, is a global industry standard number that indicates the size of the belt.

How do you rejuvenate a turntable belt?

If you want to see if you can eke out a tiny bit more life from your belt, boil some water, take the pot off the stove, and drop the belt into the water for a five minutes. Obviously, let it dry thoroughly before putting it back on the turntable.

Can you repair a turntable belt?

A record player belt connects the motor to you turntable, spinning it at a constant pace. While they rarely snap, they can wear down and slip off. Luckily, the replacement is easy, and you can do it at home with minimal tools or effort.

How do you change a drive belt on a record player?

How to install a drive belt on the turntable.

  1. Lift up the Dust Cover and remove it from the turntable Base.
  2. Remove the Rubber Mat from the Platter.
  3. Lift the Platter straight up off the Spindle.
  4. Slip the Belt around the underside of the Platter.
  5. Place the Platter back on the Spindle.

What are the 2 types of drive belts?

There are three types of drive belts:

  • Serpentine Belt. A serpentine belt is located under the hood of a car, and it “snakes” its way between various pulleys and accessories.
  • V-Belt. A V-belt runs off a crank and pulley and typically travels between one or two engine accessories.
  • Timing Belt.

How long should a turntable belt last?

But how long should your turntable belt last? Most belt-drive turntables utilize a rubber-based closed loop belt that typically lasts up to 5 years or so. The lifespan of the belt is determined by its quality, tightness, elasticity, and use. With no use, a belt will last 5-6 years in typical conditions.

  • August 16, 2022