How do I reprogram my Somfy shades?
Table of Contents
How do I reprogram my Somfy shades?
Press and hold the programming button of that transmitter until the shade jogs. Select the transmitter (single channel) or the channel, (1-5) of a multi-channel transmitter, to be added or deleted. Press and hold the programming button of that transmitter until the shade jogs. A jog is a brief up and down motion.
How do I program a Somfy receiver?
Press and hold the program button on the telis transmitter until the LED on the receiver turns off. Release the program button and the LED will light again. Press and release the program button on the same transmitter again and the LED will turn off and remain off. This transmitter is now memorized.
What is RTS in programming?
Short for Request to Send, RTS is a signal sent by a communications device, like a modem, to verify the other device is ready for data reception.
What is RTS RS485?
PRODUCT DESCRIPTION. The RS485 RTS transmitter is a motor controller which allows to manage all your Somfy RTS applications with the same centralized home control system. It can control up to 16 groups of SOMFY RTS motors and receivers. It is impossible to set a motor or a receiver with this RS485 RTS transmitter.
How do I reset my Somfy RTS engine?
Procedure:
- Start with having power applied to the motor.
- Remove the power for 2 seconds.
- Re-apply power for 10 seconds.
- Remove the power for 2 seconds.
- Re-apply power. The shade will begin to move.
- When it stops moving, press and hold the programming button on the back of the remote until the treatment jogs twice.
How do I use the Somfy reset tool?
Insert plug end on this tool into motor located on the end of the motor. Press down the red button on tool and light will illuminate. Hold down on button until the red light goes out. Motor is now reset.
What is RTS control?
RTS Control is a method with which the RS232 device (typically a PC) tells an RS232-RS485 converter when it should enable its RS485 driver, i.e. when it should be transmitting. There is no technical reason why the converter cannot determine this by itself but it increases the cost of the converter.
What is RTS signal?
RTS / CTS Flow Control is another flow control mechanism that is part of the RS232 standard. It makes use of two further pins on the RS232 connector, RTS (Request to Send) and CTS (Clear to Send). These two lines allow the receiver and the transmitter to alert each other to their state.
