Blog

How do I reset my Cisco SPA 508g?

How do I reset my Cisco SPA 508g?

Factory Reset

  1. On the phone press the setup button.
  2. Use the directional pad and go down to Factory Reset.
  3. Click OK to perform the factory reset, the phone should now reboot and default back to the factory default configuration.

How do I reset my Cisco SPA 514g?

You can reset Cisco SPA302, SPA303, SPA501G, SPA502G, SPA504G, SPA508G, SPA509G, SPA512G, and SPA514G phones by following the steps below:

  1. Press the Menu button.
  2. Press Setting.
  3. Navigate down to Factory Reset option.
  4. Press select.

Do Not Disturb is active Cisco IP phone?

You can also enable or disable the feature on a per-phone basis from within Cisco Unified Communications Manager. When you enable Do Not Disturb, the Cisco Unified IP Phone displays the message “Do Not Disturb is active”. Some Cisco Unified IP Phones display DND status icons.

How do you deactivate Do Not Disturb on landline?

  1. Dial *78# on your home phone to activate the Do Not Disturb feature. When activated, callers hear “The party you called is not currently accepting calls. Please try again later.”
  2. Dial *79# to deactivate the feature when you are ready to receive calls.

How do I reboot my Cisco phone remotely?

Simply add /admin/reboot to the phone’s IP in web URL (e.g. http://192.168.0.51/admin/reboot) and providing there are no active calls, phone will reboot.

How do I take my phone off Do Not Disturb?

Turn off Do Not Disturb

  1. Swipe down from the top of the screen and tap your current option: Alarms only , Priority only , or Total silence .
  2. Press the volume down button and tap Turn off now.

How do I take my home phone off Do Not Disturb?

Dial *78# on your home phone to activate the Do Not Disturb feature….Turn Do Not Disturb on and off

  1. Go to Phone Features.
  2. From Feature Controls, select Do Not Disturb.
  3. Select On or Off.
  4. Select Save.

What is the code for do not disturb?

2442
DND (Do Not Disturb) For Full DND, Text STOP to 2442. To receive all messages, Text ALLOW to 2442. To check DND status, Text STATUS to 2442. To opt out of the service, SMS the word “ALLOW” to the short code 2442.

How do I reset my voicemail password on my Cisco IP Phone?

KNOWN ISSUE: Do not access this through Settings in your Web Inbox; please use link below.

  1. Log in to the Cisco Personal Communications Assistant (PCA) Messaging Assistant: https://nsas-pucxn-01.doit.wisc.edu/ciscopca/home.do.
  2. Select Messaging Assistant.
  3. Select Passwords/Change PIN.
  4. Enter New PIN.
  5. Confirm New PIN.

Does restarting router change IP?

The common nature of DHCP is to “remember” the device and assign you the same IP address you had before, so simply turning off your router and turning it back on will not likely change IP address. However, if you try multiple times you may get lucky and will obtain a new IP address from your ISP.

  • July 28, 2022

You may also like...