How do you use Wella Color Touch as a toner?
Table of Contents
How do you use Wella Color Touch as a toner?
Always mix 1 part COLOR TOUCH + 2 parts of COLOR TOUCH Emulsion 1.9%. Apply to pre-shampooed, towel-dried hair. Develop up to 20 minutes. When desired results are achieved, rinse until the water runs clear, towel-dry and apply your chosen COLOR TOUCH target shade in the normal way.
How long do you leave Wella color touch toner on?
5-20 mins
5-20 mins Perfect toning choice as Color Touch Relights contains no depth, so is ideal to keep your blondes bright and tonal.
Does Wella Color Touch run dark?
Although the color says dark blond, Color Touch and Koleston actually run dark. Koleston by one level and Color Touch by two.
Do I shampoo before toner?
It’s easiest to apply toner to hair that’s still a bit wet, so dry your hair enough so that it’s still slightly damp but not dripping. If you’re not using toner right after bleaching, simply wash your hair with shampoo beforehand and towel dry the same way.
What do you mix Wella color touch with?
Mixing ratio of 1:2, e. g. 30 g Cream + 60 g Intensive Emulsion. All shades are intermixable and can be used directly after a perm or straightening service. Color Touch Sunlights can not be mixed with products from another line, e. g. Color Touch Baseline or Koleston Perfect.
Do you shampoo after toner Wella?
It’s best to wait at least 24 hours before you shampoo your newly-toned hair to make sure the color won’t fade before it’s fully set in.
Should you put toner on wet or dry hair?
damp
Your hair has to be a little damp or towel dried while applying a toner. To be precise, you should always use a hair toner when your hair is 70% dry. You will achieve better results if you put toner on damp hair and not dripping wet or completely dry hair.
Do you put Wella toner on wet hair?
Apply your Wella Toner to damp, towel dried hair. This will help the toner not to ‘grab’ at sections of the hair (which can leave some parts more toned than others).
How long should I leave Wella T10 in?
It’s simple to use! Just mix the toner with your chosen developer (we use Hi Lift and you can find it on this shop). Apply to damp, towel dried hair. Leave on your hair for up to 30 minutes and rinse out.
What does Wella toner T10 do?
Wella T10 toner, also called “Ivory Lady,” is a pale blonde liquid toner. It’s formulated to cancel out all the brassy tones that show up after lightening dark hair.
