How much gain does the dbx 286s have?
Table of Contents
How much gain does the dbx 286s have?
-30dB to +10dB
Specifications
Mic Preamp Connector | XLR Floating balanced, Pin 2 Hot |
---|---|
Max Output | >+21dBu, >+20dBm (600Ω load) |
Gain Adjustment Range | -30dB to +10dB |
Noise | <-80dBu unweighted (20Hz-20kHz); Both Gain Controls set for 0dB, all processing controls OFF |
Frequency Response | 20Hz to 20kHz, +0.5, -0.5dB |
What does a microphone processor do?
The mic processor adds additional power to the preamp. Typical stages include a gate or expander, limiter, compressor, de-esser and equalization. Each stage can be used for a particular benefit. Just like an on-air processor, these stages of a mic processor each have their own operational benefits.
What does a preamp do for vocals?
The purpose of a preamp is to amplify low level signals to line level, i.e. the “standard” operating level of your recording gear. Microphone signals are usually way below the nominal operating level, so a lot of gain is required, usually around 30-60 dB, sometimes even more.
Do I need a dbx 286s?
Bottom line-The dbx 286s should be the 1st preamp considered for live and home studio users that don’t have a gazzillion bucks to spend. Actually, even if you do have a gazzillion bucks, the 286s is a very good mic preamp option. Solid performance w/o a break the bank price point.
How do you hook up a preamp to a laptop?
1) Use a stereo 1/8″ (3.5mm) stereo mini plug to RCA stereo adapter or cable to connect the headphone out on the laptop to the pro-ject preamp line-in. Plug you headphones into the preamp’s headphone jack. You are done.
What type of mics need preamp?
A preamp is one of those essential items for your studio. If you use a condenser microphone, which requires 48v phantom power to work, you’ll need a preamp to provide it! But, of course, any microphone benefits from a good preamp, including ribbon and dynamic mics.
What is the only difference of two stage preamplifier over microphone preamplifier?
Although a microphone preamplifier and an amplifier both act to boost signal level by applying gain, there is one key difference between the two: A preamp boosts a weaker mic level signal to line level, while an amplifier boosts a line level signal to speaker level.
Can you use a mic preamp with an audio interface?
As a rule – only connect microphones to mic inputs, and line outputs to line inputs. We really must stress this point: If you plug an external mic preamp to an audio interface, you must ignore the interface’s mic inputs, and plug your preamp’s line output straight to a line input.
Are mic preamps worth it?
A high quality microphone preamp, however, will do much more than just make your mic level louder. It will deliver a cleaner, more accurate signal, with higher gain, lower noise, less distortion, and more headroom.