How do you reset the check engine light on a 2012 Jeep Wrangler?
Table of Contents
How do you reset the check engine light on a 2012 Jeep Wrangler?
Resetting the Check Engine Light:
- Make sure the engine is not running and key is out of the ignition.
- Disconnect the battery terminals.
- Wait 5 minutes.
- Reconnect battery terminals.
- Insert and turn the ignition key to the run position without starting.
- All error codes are cleared and CHECK ENGINE icon disappeared.
How do I set up Bluetooth in my 2012 Jeep Wrangler?
How to Set up Bluetooth in Your Jeep
- Make sure Bluetooth is activated on your mobile device and that the vehicle is stopped or in park.
- On your Jeep Uconnect screen, press the Phone button > Add Device > Settings.
- On your mobile device, select your Jeep from the Bluetooth menu.
How does Jeep hill descent control work?
HDC when engaged, will detect steep declines and automatically apply controlled brake pressure to control the speed of the vehicle while descending down a hill. The feature is intended for low-speed off-road driving, in conditions where you feel the need to allow the Jeep to control your speed during your descent.
How do I program my Jeep TPMS?
Hold TPMS tool on left front tire sidewall next to the valve stem. Repeat for the right front, right rear and left rear tires. Apply OBD module to the DLC. Turn ignition ON.
How do you reset the TPMS light on a 2012 Jeep Grand Cherokee?
Start the car and wait 20 minutes for the sensor to refresh. The tire pressure monitor reset button is usually located beneath the steering wheel.
When should you use hill-descent control?
When Should I Use Hill-Descent Control? Hill-descent control was primarily created for, and is most often used for, going down a steep grade on rough terrain. This usually happens when you’re off-roading. You shouldn’t be using it while traveling down the highway.
Does hill-descent control use brakes?
Available Hill Descent Control™ uses the traction control system with anti-lock brakes. It adjusts braking pressure to help control slippage and maintain a constant preset speed while you are going down a steep grade.
How do I activate hill descent control?
The first thing you need to do is press the hill descent control button in your Ford vehicle. This is located above the display screen on your center console. Once you press the button, you’ll see a light appear and a chime will sound. These let you know that the feature successfully activated.
