What are safety wire pliers used for?
Table of Contents
What are safety wire pliers used for?
Secure fasteners or electrical connections with this handy safety wire twister tool. The heavy-duty construction, spring return and locking jaws make tedious chores a piece of cake. Simply clamp the wire with the pliers, lock the jaws in place and then pull back to create a uniform twist.
Who makes milbar safety wire pliers?
18. The Milbar Company of Chagrin Falls, Ohio, a manufacturer of specialty hand tools since 1956, was acquired by Stride Tool Inc. in 1995. The world’s leading manufacturer of safety wire twisters, Milbar wire twisters are an integral part of Strideﾒs business.
What size is safety wire?
Safety wire is commonly 0.020, 0.025, 0.032 or 0.041 inches (0.51, 0.64, 0.81 or 1.04 mm) in diameter, but 0.021-and-0.051-inch (0.53 and 1.30 mm) diameters are also available.
Where are milbar safety wire pliers made?
the U.S.A.
Milbar Safety Wire Pliers are Made in the U.S.A.
Who makes milbar?
Stride Tool
Milbar® – World-Class Quality Hand Tools 1995 The Milbar Corporation, a Chagrin Falls, Ohio specialty tool manufacturer, is acquired by Stride Tool.
How tight should safety wire?
All safety wires “must be tight after installation, but not under such tension that normal handling or vibration will break the wire.” Twists should be “tight and even, and the wire between nuts as taut as possible without over-twisting.” (Six to eight turns per inch.)
How many twists does a safety wire have?
You should notice about 6 to 8 twists per inch with a good safety wire job. sure the bolt or stud extends at least the full round or chamfer through the nut. Turnbuckles should either have safety clips or safety wire.
When should you use a safety wire?
Safety wire is necessary in areas where a bolt could loosen during vibration. Used properly, it will lock so that the wire remains taut and prevents further movement. Think of it as wearing a belt with your suspenders.
Can you reuse safety wire?
If the fastener part to be secured does not come with a hole for the safety wire, one may need to be drilled. Safety wire is not reusable, thus it can be cut apart in order to remove it easily when the fastener is to be opened.
