How do I fix the pick motor stalled on my HP 8600?

How do I fix the pick motor stalled on my HP 8600?

Reset the printer, and then try to print again.

1. With the printer turned on, disconnect the power cord from the printer.
2. Unplug the power cord from the power source.
3. Wait 60 seconds.
4. Reconnect the power cord to a wall outlet and to the printer. note: HP recommends plugging the printer directly into a wall outlet.

How do you fix a stalled pick motor?

The “Pick Motor Stalled” Error Appears

1. Turn the printer on and wait until the printer is silent.
2. With the printer on, disconnect the power cord from the rear of the printer and unplug the power cord from the outlet.
3. Wait at least 60 seconds.

How do you clean the rollers on a HP Officejet Pro 8600?

Lightly dampen a clean, lint-free cloth with bottled or distilled water, and then squeeze any excess liquid from the cloth. Press the cloth against the roller, and then rotate the roller with your fingers. Apply a moderate amount of pressure to remove any dust or dirt buildup. Repeat this step for each roller.

How do I change the printhead on my HP Officejet Pro 8600 Plus?

Follow these steps to replace the printhead assembly in the HP printer….Replace the printhead

1. Step 1: Remove the cartridges and the printhead.
2. Step 2: Insert the new printhead.
3. Step 3: Insert the new cartridges.
4. Step 4: Return failed parts to HP.

How do I load paper into my HP Officejet Pro 8600?

To load cards and photo paper Use these instructions to load photo paper.

1. Pull out Tray 1.
2. Insert the media print-side down in the center of the tray.
3. Slide the media guides in the tray to adjust them for the media size that you have loaded, and then reinsert the tray.
4. Pull out the extension on the output tray.

How do I fix the printhead on my HP Officejet Pro 8600?

To clean the printhead, go to Tools on the printer control panel.

1. Load plain white paper into the input tray.
2. On the printer control panel, touch the Right Arrow to display additional options.
3. Touch Setup , and then touch Tools.
4. Touch Clean Printhead.
5. When the first cleaning stage completes, a test page prints.