How do you fix a Kenwood radio when it says protect?
Table of Contents
How do you fix a Kenwood radio when it says protect?
Turn off the receiver and let it cool for a few hours; then try again. If the protection mode warning doesn’t go away on its own, press the reset button. If that doesn’t work, disconnect the power lead from your receiver for 30 seconds and then reconnect it. If it still doesn’t work, it’s time to take it to the dealer.
How do I get my Kenwood radio off standby?
Press and hold the button with the magnifying glass and return arrow to exit. Hopefully this will work for you. I did this. I can press SRC to turn it on and off again.
Why does my home stereo go into protect mode?
If the impedance of any of the speakers is below the rated impedance range indicated on the rear of the home audio device next to the speaker connections, the home audio device may enter the PROTECT mode. Raising the volume with a low impedance speaker will trigger the protection circuit.
What does standby mean on radio?
If the BLUETOOTH/Network standby function is on, the speaker turns on automatically by operating a network device or BLUETOOTH device, and network or BLUETOOTH connection starts. The BLUETOOTH/Network standby function can be set only when the speaker is connected to an AC outlet via the AC adaptor.
Why does my car stereo keep turning on and off?
Stabilize Unstable Voltage Your stereo will lose sound when the voltage gets too low. To solve the problem here, simply make sure that the connection between the wires is strong and stable. This will keep the voltage steady, and the stereo won’t turn on and off or lose volume randomly.
How do I reset push power protect?
Turn off the home audio device, and remove all speaker wires from the back. Then turn the device back on and check if the issue is resolved. If it is still having the same issue, turn off the device again and let it rest for at least 30 minutes before turning it on again.
What does push power protect mean?
The PROTECT and PUSH POWER messages will flash alternately when the protective device of the amplifier has been activated because a strong signal was input, or if there is a short-circuit detected. To resolve the issue, turn the amplifier off and leave it off for at least 30 minutes.
How do I turn off auto standby?
Setting the Auto Standby function (Auto Standby)
- Select [Settings] – [System Settings].
- Select [Auto Standby].
- Select [Off] to disable the Auto Standby function; or [00:20] (factory default setting), [01:00], or [02:00] to specify the period of time before the function is activated.
Why does my stereo randomly shut off?
If a receiver is not getting enough current, it will turn itself off. If your receiver shares a wall outlet with another high-current appliance (such as a refrigerator, air conditioner, heater, or vacuum), the receiver may shut itself off when there is insufficient current.
Why does radio keep cutting out?
There may be a break, weak point, or loose connection in the wiring between the SiriusXM antenna and the tuner. Or there could be the same issues in the wiring between the tuner and your stereo. This can affect the sound quality and it may cause the radio to cut out often.