What are Category II operations?

What are Category II operations?

Category II operations involve the airplane owner or operator, the maintenance personnel and facilities, and the flight crews.

What aircraft maintenance inspections are required?

There are two main aircraft maintenance inspections required for Part 91 aircraft: the annual and 100 hour inspections. Whether you do both or only one depends on if you carry any passengers for hire. Both inspections cover the same items.

What are the types of cleaning agents used on aircraft?

In general, the types of cleaning agents used on aircraft are solvents, emulsion cleaners, soaps, and synthetic detergents. Their use must be in accordance with the applicable maintenance manual.

What is a Part 23 airplane?

Specifically, the new part 23 revolutionizes standards for airplanes weighing 19,000 pounds or less and with 19 or fewer passenger seats by replacing prescriptive requirements with performance-based standards coupled with consensus-based compliance methods for specific designs and technologies.

What are the 2 types of maintenance in aircraft?

Scheduled or preventive work to anticipate and prevent failures. Unscheduled work – Repair maintenance and On-condition maintenance.

What are the methods of cleaning aircraft interior?

Cleaning of cabin windows inside shall be done only with an approved cleaning product and a non-abrasive cloth. Once the window is cleaned, rinse with water using a cloth and dry the surface. Cloth-covered seats shall be vacuumed. Sticky objects shall be removed with a spatula prior to vacuuming.

What is a Part 25 airplane?

Part 25. This part contains airworthiness standards for airplanes in the transport category. The Boeing 737 and later types, and Airbus A300 series, are well-known airplane types that were certified according to standards set out in FAR Part 25.

What is the difference between Cat 1 and Cat 2 ILS?

CAT I relies only on altimeter indications for decision height, whereas CAT II and CAT III approaches use radio altimeter (RA) to determine decision height. An ILS must shut down upon internal detection of a fault condition.

What is C check in aviation?

C Checks. C and D checks typically fall under “heavy maintenance,” and are much more extensive than the B check. The C check requires an aviation maintenance technician to perform a deep inspection of a majority of the aircraft’s parts.

What are the two types of aircraft cleaning?

Cleaning Methods For aircraft exterior cleaning there are three major methods; wet wash, dry wash, and polishing. Polishing can be either done manually by hand or the polishing activity can be performed using specialized mechanical polishing machines.

What is deep cleaning in aircraft?

If a plane sits for longer than eight hours — typically a long-haul jet — then the airline will perform a deep clean, a member of the Delta operations team explained. During a deep clean, every seat cushion is removed, the seats are vacuumed and the carpet is shampooed throughout the cabin.

How much does it cost to detail an airplane?

Expect to pay around $1000 to wet wash the exterior of a large business jet, such as a Gulfstream G650 that carries between 11 and 18 passengers. Airplane detailing costs will typically rise to around $2,500 for a larger commercial aircraft.

How often do airplanes get cleaned?

This is a step-by-step visual account of the flight. A spokesman for United Airlines wrote in an email that the airline was deploying electrostatic spraying before “most flights.” Southwest Airlines wrote in an email that their aircraft are deep cleaned for six to seven hours every night.