What does a Stratix switch do?

What does a Stratix switch do?

With redundant gateway capabilities, the Stratix 5700 can support two switches on a single ring while being directly connected to the rest of the network helping to provide increased resiliency. The switch also offers DHCP IP address assignment to end devices on the DLR network for simplified device replacement.

Is stratix a Cisco switch?

The Allen-Bradley Stratix 5700 is a compact, scalable Layer 2 managed switch with embedded Cisco technology for use in applications with small isolated, to complex networks.

How do I find the IP address of my Stratix switch?

Software Configuration for the Stratix Switch 5700 This setting can be found in Control Panel > Network Settings > Network Adapters > “EtherNet” Properties. Here, you can setup the switch by giving it a name, an IP address as well as a gateway mask.

What is the default IP address for Stratix 5700?

Type the Stratix 5700 IP address, 192.168. 1.201, in the address bar and click Enter.

Does Cisco support DLR?

CPwE DLR is an extension to CPwE Resiliency and was architected, tested, and validated by Cisco Systems and Rockwell Automation with assistance by Panduit. An IACS is deployed in a wide variety of industries such as automotive, pharmaceuticals, consumer packaged goods, pulp and paper, oil and gas, mining, and energy.

How do you hook up a Stratix switch?

Connect a Category 5 Ethernet cable from the flashing switch port to the Ethernet port on your personal computer. The port status indicators on your personal computer and on the switch both flash while the switch configures the connection. IMPORTANT Do not use the console port for Express Setup.

What is Cisco dlr?

DLR refers to the abandonment of physical switches and using the embedded dual ports on the Rockwell devices. It uses the end devices to create the ring. Neither the Stratix family of switches or the IE-2000s pertain to this.

What is a DLR network?

Device Level Ring Networks Device Level Ring (DLR) is an EtherNet/IP™ protocol that is defined by the Open DeviceNet® Vendors’ Association (ODVA). DLR provides a means to detect, manage, and recover from single faults in a ring-based network.

Can I use RJ45 with SFP?

Compared to SFP/RJ45 ports, these 4 combo SFP/RJ45 ports allow users to use either SFP port or RJ45 port at a time for short-distance connections. Now we know when the link distance is over 100 meters, SFP port with fiber SFP module must be considered instead of RJ45 Ethernet port with Ethernet cable.

How many devices can be in a DLR?

For all types of rings, we recommend that you limit a DLR network to fewer than 50 nodes. If your application requires 50 or more nodes, we recommend that you segment the nodes into separate DLR networks. For rings of only switches, we recommend that you use no more than 24 switches and 230 end devices.

Can SFP talk to SFP+?

SFP modules may can be used in SFP+ slot, but a SFP can never be connected to a SFP+ module. For their different speeds, transmission distance and wavelength. 10 SFP+ only can use for 10G SFP+ port, and can never auto-negotiate to 1G.