What is policy-based routing?
Table of Contents
What is policy-based routing?
Policy-based routing is a process whereby the device puts packets through a route map before routing them. The route map determines which packets are routed to which device next. You might enable policy-based routing if you want certain packets to be routed some way other than the obvious shortest path.
How do you set up a policy route?
Configuring a policy route
- Go to Network > Policy Routes.
- Click Create New > Policy Route.
- Configure the following fields: Incoming interface. port1. Source Address. 0.0.0.0/0.0.0.0. Destination Address. 0.0.0.0/0.0.0.0. Protocol. TCP. Destination ports. 21 – 21. Type of service. 0x00. Bit Mask. 0x00. Outgoing interface.
- Click OK.
What is policy-based routing in Asa?
This post describes how to configure a Cisco ASA firewall to support Policy Based Routing (PBR). PBR allows an administrator to define routing based on source address, source port, destination address, destination port, protocol or a combination of all these.
Which is a characteristic of policy-based routing PBR )?
With PBR, a network engineer has the ability to dictate the routing behavior based on a number of different criteria other than destination network, including source or destination network, source or destination address, source or destination port, protocol, packet size, and packet classification among others.
What is policy routing in Fortigate?
Policy routing enables you to redirect traffic away from a static route. This can be useful if you want to route certain types of network traffic differently. You can use incoming traffic’s protocol, source address or interface, destination address, or port number to determine where to send the traffic.
What is port based routing?
Port based routing is a process that sends all the packets with a certain destination port to a certain IP which is not the configured default gateway.
What is static route in FortiGate?
Static routes specify the IP address of a next-hop router that is reachable from that network interface. Routers are aware of which IP addresses are reachable through various network pathways, and can forward those packets along pathways capable of reaching the packets’ ultimate destinations.
How do I configure FortiGate routing?
Specify the IP address of the next-hop router where the FortiADC system will forward packets for this static route….To configure a static route:
- Go to Networking > Routing.
- Click Add to display the configuration editor.
- Complete the configuration as described in Table 103.
- Save the configuration.
What is policy-based routing Fortigate?
What is PBR Fortinet?
The purpose of this article is to describe the Fortinet PBR (Policy Based Routing) behavior by design. The PBR should work with the IP written in the “gateway” label of the policy that represents a general hop, not necessary the next hop, in the network reachable via routing table in the same FortiGate unit.
