What would cause a Chevy Blazer not to start?
Table of Contents
What would cause a Chevy Blazer not to start?
The most common reasons a Chevrolet Blazer won’t start are a dead battery, an alternator problem, or failed starter.
Where is the fuel pump relay on a 93 Chevy Blazer?
The fuel pump fuse in your 1993 Chevrolet S10 Blazer is most likely labeled ECM or ECM B. Check the fuel pump relay which is under the hood, on the drivers side fire wall. If you do not keep at least a 1/4 tank of gas in the tank to lubricate the pump they go bad. Thr fuel pump fuse is in the fuse box under the dash.
How do you jumpstart a Chevy Blazer?
How to Jump Start Your Car
- Turn off both cars.
- Pop the hoods.
- Attach jumper cables.
- Start the functioning car.
- Wait a few minutes.
- Try to start the car with the dead battery.
Where is the fuel pump relay on a 94?
New Answer: the relay is in front of the shifter under the dash if you get the panels off (shifter cover , lower center panel and left center panel you can see it and the PCM power relay if you lay on passenger floor and look to rear of center area.
Where is the fuel pump reset button on a 1994 Ford Ranger?
It’s located under the dash in the passenger foot area, just at the front edge of the carpet. At the top of the switch is a white button, push it down to re-set it. It should fire right up.
What pins to jump a relay?
The fuel pump primes when the ignition switch is in run. If you want to jump the fuel pump relay it will be pin 30 to 87.
How do I auto start my Chevy Blazer?
Remote start your Chevy Blazer with your OEM factory key by pressing the lock button 3x. Your vehicle will run for 15-60 minutes and when you are ready to leave, just enter the vehicle, buckle up and drive away.
What is passive door unlock Chevy?
Passive Locking — Automatically locks doors and trunk/liftgate after you turn off the vehicle, exit with the key fob and close all the doors. Passive Unlocking — Determine which doors unlock upon the first press of the button on the driver’s door.
