How do I change the ribbon on my brother fax?

How do I change the ribbon on my brother fax?

Install the new ribbon in the cartridge:

1. Slip the lower left cardboard core onto white spool of the cartridge and then slip the upper blue core onto the blue gear of the cartridge.
2. Insert the upper and lower right white spools into the holders.

How do I change the ribbon on my Brother printer?

How to install the ink cassette ribbon

1. Use the SPACEBAR or BACKSPACE key to move the carriage to the center of the platen.
2. Open the top cover.
3. To remove the cassette ribbon, hold the cassette with both hands and raise the front end (near the platen).
4. Lift the used cassette ribbon up and out.

What does ribbon empty mean on a fax machine?

The message “Ribbon Empty- Reset or Replace” will appear on the display of your Brother machine when your ribbon cartridge has run out and needs to be replaced. Replace the ribbon by following the instructions below: Open the top cover by lifting the lever on the right side of the top cover.

How do you put the ribbon on a Brother fax 575?

Installing the ribbon refill

1. Open the top cover by lifting the gray lever on the right side of the machine and lifting the cover.
2. Remove the used print cartridge, then flip the cartridge over and set it down.
3. Snap out the white spools on the right side of the cartridge.
4. Remove the two white spools from the used ribbon.

How do you change the ribbon on a Brother fax 575?

What does ribbon empty mean?

This error message means your fax machine is out of ribbon or the print cartridge isn’t properly installed. For instructions on how to replace the print cartridge or ribbon, refer to Replacing the print cartridge or ribbon. Click here to display all models covered by this answer.

How do you reset a fax?

If your machine has FAX functions: Press Settings. Press the Up or Down arrow key to display Network, and then press OK. Press the Up or Down arrow key to display Network Reset, and then press OK. Follow the machine’s instruction to reset the network settings.

How do I test my brother fax 575?

How to Test a Brother Fax Machine

1. Insert a document to fax into the fax machine’s page loader.
2. Dial 1-888-473-2963 (1-888-hpfaxme) on the fax machine’s keypad.
3. Press “Start” or “Send” on the fax machine to begin the transmission.
4. Wait a few moments for a return fax from the HP Fax Test Service line.

How do I reset my brother fax 575?

Reset Your Brother Machine

1. Press. [Settings]>[All Settings]>[Initial Setup]>[Reset].
2. Swipe up or down or press or. to display the type of reset functions, and then press the reset function you want to use.
3. [Machine will reboot after resetting. Press [OK] for 2 seconds to confirm.]
4. Press .

How do I reset the drum on my Brother fax machine?

If you reset the drum counter during the life of the drum unit currently being used, the remaining drum life will not be displayed accurately.

1. Make sure that the machine is turned on.
2. Open the front cover.
3. Press and hold OK for 2 seconds.
4. Press the Up arrow key or 1 to reset the drum counter.
5. Close the front cover.