How do you diagnose and fix a Hoover E03 error code?
Table of Contents
How do you diagnose and fix a Hoover E03 error code?
The machine is unable to drain the water away. Should the error code E3 appears it is warning that the machine is not draining. You can easily fix this problem by removing any blockages from the drain pump situated at the front of the machine for easy access.
What does eo3 mean on washing machine?
An E03 error code means that your washing machine has encountered a draining problem.
Why is my Hoover washing machine flashing?
Hoover washing machine e03 means that your washing machine has a draining issue. This fault may also be indicated by LED lights flashing three times before pausing – and then repeating. The problems that prevent drainage include blockages in the drain filter or the drain pump. The pump may also be defective.
What does E08 mean on washing machine?
If you put too many clothes in the drum and overload the machine it may result in error code E08 being displayed. Should this occur then reduce the load size by removing some of the garments in the drum and try again.
What does error code F01 mean?
failed electronic machine control board
The F01 indicates a failed electronic machine control board. This error code can sometimes be caused by a glitch or power surge through the electrical lines. You may be able to clear this code by unplugging the washer for 5 minutes.
What does E02 mean on a Hoover?
If error code E2 appears in your display there is a problem with the water supply. It may be that the water pressure is very low or no water is flowing in. Check that the water supply is switched on or that the hose has not got twisted or kinked during the installation which will prevent water flowing into the machine.
What does it mean when all lights flashing on washing machine?
If the wash, rinse and spin function lights all flash at the same time, this would indicate a possible blockage in your filter or waste / drain pipe.
Why is my washing machine display flashing?
if the wash, rinse, and spin function lights are all flashing at the same time this indicates a potential obstruction in the drain or waste pipe. Worn carbon brushes can also cause this to happen.
Why is my Hoover washing machine not draining or spinning?
If the washer won’t drain or is not draining properly, and the washer has a coin trap, remove the coin trap and clean it thoroughly. First, check the drain hose to determine if it is kinked, twisted, or bent. If the drain hose is bent, straighten it out. In addition, remove the drain hose and check it for obstructions.
How do I get my washing machine to drain?
How to drain a washer filled with water
- Try the spin cycle.
- Turn off the power and water supply.
- Remove and check the drain hose.
- Check to see if it will drain with the help of gravity.
- Check your machine’s inner workings.
- Check the drain pipe.
- Drain manually if needed.
- Call a service professional.
How do I fix error code E08?
How to Diagnose and Fix Fault Code E08
- Switch off and unplug your machine.
- Check the motor speed sensor.
- Check the wiring and connections to the speed sensor.
- If the motor is not turning check the motor itself.
What does E008 mean?
The E008 error code is related to the throttle, which is typically an easy fix. Check your throttle cable to make sure it wasn’t disconnected. Then follow the cable from your throttle down to its quick plug; you may need to unravel some of the plastic wrapping to find access.
