How thick are Strat pickguards?
Table of Contents
How thick are Strat pickguards?
.095″
Measures 9″ x 15″ and . 095″ thickness. Large enough for a Strat® pickguard and backplate, P Bass®, etc.
Why do pickguards shrink?
Exposing celluloid to moisture, light, air, and acids causes it to break down. In the case of old pickguards, this usually means shrinkage. The original footprint of the pickguard may start to show around the edge as it shrinks, or the edges may curl up (the technical term for that is “potato chipping”).
What are fender pickguards made of?
Pickguards fitted to acoustic guitars are usually made from thin (2 mm) sheets of plastic (such as PVC), attached with an adhesive just below the sound hole. The material should not be unduly thick or heavy since this might reduce vibration of the soundboard and alter the tone or volume of the instrument.
Is it hard to replace pickguard?
Replacing your pickguard is a relatively simple undertaking, but as with any guitar mod, it’s important to plan ahead by having the right tools and understanding each step of the operation.
When did Fender stop using celluloid pickguards?
Celluloid had vexing drawbacks, however – aside from being so extraordinarily flammable that few dared work with it, it was prone to shrinking, warping and cracking. Consequently, Fender switched to less temperamental plastics for its multi-ply pickguards around 1965.
When did Fender stop using clay dots?
1965
A little history: Clay position dots were first used by Fender in 1959, with the introduction of rosewood fingerboards on their instruments. Clay dots were discontinued in early 1965 and replaced by slightly larger 9/32″ (7.14mm) pearloid dots.
What is the point of a pickguard?
The main purpose of the pickguard is to protect the guitar’s finish from being scratched by the nails of the picking hand, as it was included on guitars not played with a plectrum. The pick does not normally contact that part of the guitar when used correctly.
Is a pick guard necessary?
Pickguards are used to protect the finish of your guitar. If you play with a pick and want to preserve the finish of the guitar then a pickguard is necessary. If you don’t use a pick and/or don’t mind minor scratches or signs of wear from strumming a pickguard isn’t strictly necessary.
