Why is my hot tub water cloudy and green?
Table of Contents
Why is my hot tub water cloudy and green?
You’re not adding enough sanitizer, or adding it often enough, or both. The hot tub’s filtration system isn’t working properly, or the filter isn’t being cleaned and replaced often enough. Algae hitched a ride into your hot tub on a swimsuit or accessory that you used in another, algae-infected body of water.
How do you get rid of green spa water?
First, turn off your spa heater and balance your hot tub water. Circulate the water for a few hours (without the cover on.) Continue to shock the spa until it holds the proper sanitizer levels. After it is shocked, drain and scrub your spa with bleach and water and replace the spa filter.
Why does my hot tub water have a greenish tint?
The most common cause of green spa water is excessive metal content. Water from wells or the municipal system can contain high levels of metals such as copper or iron. Hot tub water turns green after you shock the hot tub because the oxidization reacts with copper turning it the green tint.
Is it safe to use hot tub when water is green?
If you open your hot tub to find green water then it is not only unpleasant, it prevents you using your hot tub safely and it suggests some sort of chemical imbalance.
How do I fix a cloudy green hot tub?
How to clear green water in a hot tub
- While your hot tub is not in use, remove the cover and any pillows.
- Add 60g of sanitiser (chlorine or bromine) per 1,500l of water and turn the jets on for one cycle.
- If this has worked, you’ll see the water begin to clear within 12 hours.
Does shock clear a cloudy hot tub?
Shock the water A proper sanitizer level will help destroy the particles that are causing the cloudy water. After balancing your hot tub chemicals, add a non-chlorine shock to the water. You should shock your water at least once a week or with increased use.
How long does it take for a cloudy hot tub to clear up?
It takes an average of 24 hours for cloudy hot tub water to be restored to a clear state by either using a hot tub clarifier or by hyper-chlorinating the water. However, in severe cases, a drain, clean, and refill may be necessary.
How do I make my hot tub water crystal clear?
How to fix and clear milky hot tub water
- Check your filter(s). This is your first point of call with any water quality problem, especially when clarity is an issue.
- Check the water balance levels. Your second point of call is the water balance.
- Shock the spa.
- Try a clarifier.
- Last resort, empty the spa.
Why is my hot tub cloudy but chemicals are good?
The most likely cause for your cloudy water is either due to high usage, an inadequate amount sanitizer, or both. Luckily, the fix is simple. Whether you use bromine or chlorine, add the recommended dosage and allow it to filter.
How do I stop my hot tub water going cloudy?
How Do You Clear Up Cloudy Water in The Hot Tub?
- Check water pH and Alkalinity levels. You can test your water using a test strip and drop-style kits.
- Shock treatment.
- Check and clean the filters.
- Use algaecide or water clarifier.
- If nothing else helps, drain and refill the hot tub.
How do I get my hot tub water clear again?
Does shock clear cloudy water?
To eliminate any contaminants or chloramines in your cloudy pool water, add a high dose of chlorine by shocking your pool. If the cloudy water in your pool is due to a pool algae bloom, you’ll have to double or triple shock depending on the type of algae you have.
How many times can you shock a hot tub in a day?
In essence, shocking your hot tub means adding a higher than usual dose of oxidiser chemicals to the water. This is also known as oxidising. We advise everyone to shock their water once a week to reduce bacteria and impurities. You can do this with one of two products; chlorine shock or non-chlorine shock.
Can you shock a hot tub more than once a week?
Regular hot tub shocking is inevitable to keep your water clean and safe for use. Dead skin and other elements like hair may end up dropping in the hot tub, leaving the tub in a mess. It is essential to shock the hot tub frequently – at least once every week.
What happens if you put too much shock in a hot tub?
You only need a small amount of chlorine to successfully sanitize your spa, so it’s possible to overdo it if you’re not careful. Too much chlorine can damage your hot tub and irritate your skin, eyes and lungs. Thankfully, reducing the chlorine levels in your hot tub is very easy to do.
What happens if you put too much chlorine in a hot tub?
No. It’s not safe to get in a hot tub where chlorine levels are above 3 parts per million on your test strip. Levels above that can lead to red, itchy skin & eyes, & respiratory issues. Levels over 5ppm can lead to chlorine poisoning which adds the symptoms of nausea, vomiting, and difficulty breathing.
What is the difference between spa shock and chlorine?
Is Spa Shock the same as Chlorine? Sodium dichlor shock is a form of chlorine and can act as both sanitiser and shock treatment. If you’re using a chlorine-free shock product like MPS (potassium peroxy-monosulphate), then this will not have any chlorine in it.
