How do I get my JVC out of demo mode?

How do I get my JVC out of demo mode?

1 Press and hold SEL for more than 2 seconds so that one of the PSM items appears on the display. or 4 to select “DEMO.” 3 Press – to select “DEMO OFF.” 4 Press SEL (Select) to finish the setting.

How do I reset my JVC car stereo?

First, locate the reset button on your JVC car stereo. This is usually located behind the faceplate of the unit. Once you’ve found the reset button, press and hold it for about five seconds. After a few seconds, you should see the message “RESET” appear on the display of your stereo.

How do you reset a JVC protect mode?

Registered

1. Disconnect all power from the unit.
2. Simultaneously press and hold the [MENU] and [Skip Track] buttons.
3. While holding down both [MENU] and [Skip Track] , apply 12v power to unit.
4. Press [Skip Track] until the display shows “DC1 ERR”
5. Press [Pause] and advance display until “DC2” appears.

How do I get my Sirius radio off demo mode?

Demo mode is a feature for retail display purposes, and the Radio will automatically exit demo mode once it begins to receive a good signal. To exit demo mode immediately, press and hold the Select button for 10 seconds. Demo mode can be disabled, if desired, by following the instructions in “Demo Mode” on page 52.

How do you turn off demo mode on a Sony radio?

Follow any of these methods to turn off DEMO mode:

1. Method 1. Press the HOME buttton on the unit. Touch Settings. Touch General. Touch Demo to set it OFF.
2. Method 2. Press the HOME buttton on the unit. Touch Settings. Touch Screen Settings. Touch Demo to set it OFF.

How do I turn off demo mode on my Kenwood?

Exiting the Demonstration mode

1. Press the [Control knob] to quit the Demonstration mode when the message “CANCEL DEMO PRESS VOLUME KNOB” appears (approx. 15 seconds).
2. Turn the [Control knob] to select the “YES” and then press the [Control knob]. The Demonstration mode can also be canceled in the Function Setting mode.

What causes a radio to go into protect mode?

Your stereo receiver is going into protection mode because the receiver has an internal short, a speaker is bad or the speaker wiring has a problem, such as incorrect wire gauge or bad connections.