How do I reset my blower limit switch?

How do I reset my blower limit switch?

How to Reset a Furnace Limit Switch

  1. Locate your furnace’s heating duct.
  2. Locate the white limit switch.
  3. Look at each arm to identify the settings.
  4. Identify the component (setting) located in between the two arms.
  5. Set the temperature on the middle component to approximately 105 to 115 degrees Fahrenheit.

Should furnace fan run constantly?

As previously mentioned, newer models of furnace systems include fans that are designed to run continuously. Assuming that your heating equipment was properly installed by a professional and has correctly-sized ductwork, letting the fan run continuously may actually help extend its service life.

What causes a furnace limit switch to trip?

If the air inside your furnace gets too hot, the limit switch trips to prevent overheating. If the furnace high limit switch trips due to overheating, there is likely an airflow issue that is preventing proper air movement through the system. Check your air filter, and replace it if dirty.

How does a furnace fan limit switch work?

To put it very simply, the furnace fan limit switch is a control that tells your furnace’s fan when to turn on and off. So, when the furnace isn’t on, it tells the blower not to operate (and send cold air into your home) and when the furnace is on, it tells the blower to turn on and start circulating the warm air.

Should your furnace fan be on AUTO or on?

“auto” is the best setting for your furnace fan in the winter. It will aid in saving energy and money while also working to keep your home at an optimal temperature. However, for summer, “on” is the best setting for your furnace fan.

Where is furnace limit switch located?

supply plenum
A limit switch is a device that’s located under your furnace’s supply plenum. It reads the temperature of the plenum and waits until it gets appropriately warm. Once the plenum reaches a specific temperature, the limit switch sends a signal to the air handler to begin running and delivering warm air to your home.

Is it OK to leave furnace fan on all the time?

Is it good to leave your furnace fan on all the time?

Better Indoor Air Quality Whenever the fan is on, air is going through the furnace filter. Leave it on continuously and you’re likely to see less dust around. It’s also important to have a good filter. The many types of HVAC filters can help reduce allergies, VOCs, as well as bacteria and viruses.

Should my thermostat fan be on AUTO or on?

Keeping your fan on AUTO is the most energy-efficient option. The fan only runs when the system is on and not continuously. There is better dehumidification in your home during the summer months. When your fan is set to AUTO, moisture from cold cooling coils can drip and be drained outside.

  • September 12, 2022