How do I reset my eberspacher fault code?
Table of Contents
How do I reset my eberspacher fault code?
To clear fault codes:
- While in diagnostic mode push and hold both arrow buttons until “EE” is displayed on the screen.
- To exit diagnostic mode hit the ON / OFF button.
- To shut the unit down hit the ON / OFF button again.
How do I reset my eberspacher 801?
With the heater switched on, press and hold key until the display shows ‘dA’. The blue LED will briefly illuminate. Release the key. After a short time the LED flickers momentarily during diagnostic data transfer then goes off.
How much fuel does an Eberspacher heater use?
The Eberspacher S2 D2L in use In terms of fuel consumption, the manufacturer claims the heater will use between 0.1L and 0.28L of diesel per hour, though we couldn’t easily measure this.
How does an Eberspacher night heater work?
It draws in air from inside the vehicle , heats it and expells it back into the desired compartments. Easy adjustment of the room temperature through day and night keeps you feeling comfortable warm and happy.
How do you use eberspacher 801?
To activate Ventilation Mode, press and hold the key until the blue LED illuminates and display shows active rotating two digits. Note: The 801 10 001 version will only run for a maximum period of 1 hour. To stop ventilation, press key briefly. Blue LED switches off and display shows ambient temperature.
How do I test my Eberspacher heater?
Check voltage on heater’s harness on the heater’s side (pins 1 and 10 on Airtronic connector). Turn the heater ON and make sure that the voltage is still OK. Repair harness and connections if necessary. Being turned on, heater just blows cold air, never stops and never performs a start attempt.
How do you bleed eberspacher?
You don’t need to detach any pipework to bleed it, the input to the heater is relatively low pressure. You can cycle the pump the way you describe or repeatedly restart the heater. The other way would be to use a squeezy bulb type primer or a sump pump unit (detach the pipework for this).
Do diesel heaters use a lot of diesel?
With very little fuel and electricity consumption, diesel heaters can give off a surprising amount of warmth and help make your van a cozy little abode for those dark winter nights.
How much electricity does an Espar heater use?
Technical Data:
| Fuel | Diesel – EN 590 | |
|---|---|---|
| gal/ h | 0.07 | |
| Average Power consumption | Watt | 34 |
| Average Power Consumption while Starting | Watt | 120 |
| Rate Voltage | Volts | 12 volts |
What is a hydronic diesel heater?
Hydronic air heating runs off a diesel furnace that heats coolant, which is circulated in the boat to fan heads. Hydronic systems can include water heating as well.
How do you prime an eberspacher?
Loosen off the connection at the pump, temporarily block the tank breather with a duster, apply dinghy pump to tank filler, and provided there is not too much vertical head involved, you should get diesel appearing at the pump. Tighten the connection at the pump immediately.
Why do Chinese diesel heaters smoke?
If excessive smoking of the unit is observed througout the entire cycle of the heater – you are likely to have a problem with the position or integrity of combustion impeller. That means that the combustion chamber does not get enough oxygen to burn all the fuel it has, and part of it escapes as a smoke.
Are the Chinese diesel heaters any good?
However, the Chinese heaters tend to get a bad reputation for reliability, parts availability and, most importantly, safety. Chris Emmerson of CJE Caravan Repairs has seen a lot of dodgy products come through his workshop, but increasingly he is being asked to fix issues associated with cheap ducted diesel heaters.
