How long do Hypertherm consumables last?
Table of Contents
How long do Hypertherm consumables last?
Generally though, a set of consumables will last approximately two to three hours when hand cutting and three to five hours when machine cutting. It’s important to understand that these hours apply to actual “arc-on” time.
Are Hypertherm Plasma Cutters any good?
Hypertherm Powermax30 Plasma Cutter – Best Overall For our top pick, we’ve chosen the Hypertherm Powermax30 XP. It’s one of the best plasma cutters for home use, as it’s available at a low price while offering more than enough of the features a hobbyist would need.
How long should a plasma tip last?
Usually, in normal conditions, we can say that the electrode will wear out first during machine cutting. Typical life time of a set of consumable should last about 1 to 3 hours for about 120 A of mechanized cutting, it’s in function of the job.
When should I replace my plasma electrode?
As you use the electrode, the hafnium/tungsten becomes molten and pieces of it start to blow out through the nozzle as you cut. It develops a pit at the front of the electrode. Once that pit depth is over 1⁄32, it’s time to change the consumable.
Why does my plasma cutter keeps cutting out?
Water in the air stream will “put the fire out” in the torch. It can cause the arc to be erratic and unstable and may seem like the plasma cutter isn’t working correctly. Make sure at the least you are running a small disposable in-line water separator or upgrade to a desiccant system on your compressor.
Which of the following is a common issue when plasma cutting?
Troubleshooting
| Problems | Cause of Issue |
|---|---|
| Plasma cutting torch burn out | 1. the metal pressure cap is not compressed |
| 2. cutting torch conductive joints loose, broken cable trachea, water-cooled torch interface leakage | |
| 3. cutting torch joints poor insulation |
How long should a plasma cutter tip last?
Usually, in normal conditions, we can say that the electrode will wear out first during machine cutting. Typical life time of a set of consumable should last about 1 to 3 hours for about 120 A of mechanized cutting, it’s in function of the job. Cutting at lower current may gets longer consumable life.
Why is my plasma cutter overheating?
Travel speed too slow: A slow travel speed when cutting can also cause the torch consumables to overheat and wear out parts prematurely. Be sure to move the tool at a sufficient speed, particularly at higher amperage.
