What does Chemstrip test for?

What does Chemstrip test for?

The test is useful in the initial evaluation and monitoring of renal, urinary, and metabolic disorders. The CHEMSTRIP urine test system (Roche Corporation) is a multi-parameter test strip that simultaneously measures specific gravity, pH, nitrite, protein, glucose, ketones, leukocytes, and blood in urine.

What are the 4 parameters urine strips?

4 Parameters (Glucose + Protein + Ketone + pH) Urine strips for the semi-quantitative estimation of Glucose, Protein, Ketone and pH. Most of the routine samples of urine analysis require detection of renal status of patients.

What does uro mean on a urine test strip?

Urobilinogen: This is a substance normally found in urine that occurs from the reduction of bilirubin. Too little urobilinogen can indicate liver dysfunction, too much may indicate liver disease such as cirrhosis or hepatitis.

How do you use Chemstrip 9?

Turn the test strip on its side and tap once on a piece of absorbent paper to remove any remaining urine. Hold the strip close to the color blocks to the chart on the side of the vial label. All test pads should be read at 1 minute. If leukocytes pad indicates a trace result, it should be read again at 2 minutes.

What is a normal pH for urine?

Normal Results The normal values range from pH 4.6 to 8.0. The examples above are common measurements for results of these tests. Normal value ranges may vary slightly among different laboratories.

How do you read a urinalysis test?

Normal values are as follows:

1. Color – Yellow (light/pale to dark/deep amber)
2. Clarity/turbidity – Clear or cloudy.
3. pH – 4.5-8.
4. Specific gravity – 1.005-1.025.
5. Glucose – ≤130 mg/d.
6. Ketones – None.
7. Nitrites – Negative.
8. Leukocyte esterase – Negative.

What causes urobilinogen to be high?

High levels of urobilinogen in urine may be a sign that: Your liver is making too much bilirubin because your body breaks down red blood cells faster than it can make them. This condition is called hemolytic anemia. Your liver can’t recycle urobilinogen into bile because of liver disease.

Is urine urobilinogen 2.0 normal?

The normal urobilinogen concentration in urine ranges from 0.1-1.8 mg/dl (1.7-30 µmol/l), concentrations >2.0 mg/dl (34 µmol/l) are considered to be pathological. Urobilinogen does not occur in urine, unless bilirubin gets into the intestines.

How do you read a test strip for a UTI?

Directions:

1. Simply wet one test strip by holding it in your urine stream for 1-2 seconds.
2. Read result at 1 minute for Nitrite and at 2 minutes for Leukocytes.
3. Match the color of the test strip pads to the color blocks on the foil pouch.

Does Urobilinogen make urine dark?

Urobilinogen is converted to the yellow pigmented urobilin apparent in urine. The urobilinogen in the intestine is directly reduced to brown stercobilin, which gives the feces their characteristic color….Urobilinogen.

What would cause a high pH in urine?

A high urine pH may be due to: Kidneys that do not properly remove acids (kidney tubular acidosis, also known as renal tubular acidosis) Kidney failure. Stomach pumping (gastric suction)