What does the PCM power diode do?
Table of Contents
What does the PCM power diode do?
The PCM power diode is put into the fuel pump and PCM relay power circuit to prevent power surge feedback into the circuit called flyback voltage then can be higher than normal operating voltage.
Can you replace a diode with a fuse?
If you want to make a decision on a replacement, you should check the current that the unit takes and the fuse in the circuit. If there is a 10 Amp surge, then you need a diode that can handle it. Attach your own fuse to the unit.
How do you check a PCM diode?
The Diode Test procedure is conducted as follows:
- Make certain a) all power to the circuit is OFF and b) no voltage exists at the diode. Voltage may be present in the circuit due to charged capacitors.
- Turn the dial (rotary switch) to Diode Test mode.
- Connect the test leads to the diode.
- Reverse the test leads.
How do you test a PCM diode?
How do you know if a diode is blown?
If you get an open circuit in one direction indicating the current is blocked, and a low resistance reading in the other direction, the diode is good. If there is an open circuit in both directions, the diode has failed with an open circuit.
What happens when diode fails?
However, a failed diode can short out too. In this case, the diode will exhibit a small resistance in both directions. The common reasons for a diode failure are excessive forward current and a large reverse voltage. Usually, large reverse voltage leads to a shorted diode while overcurrent makes it fail open.
What happens when a diode goes bad?
How do you know a diode is bad?
A diode is reverse-biased when the positive (red) test lead is on the cathode and the negative (black) test lead is on the anode. The reverse-biased resistance of a good diode displays OL on a multimeter. The diode is bad if readings are the same in both directions.
