What is the fastest Pinewood Derby car design?
Table of Contents
What is the fastest Pinewood Derby car design?
The Black PRO Car is our fastest pinewood derby car. It pushes the Speed Limit! It is track-tested car ready to race featuring our race winning PRO friction-free BSA Ultra-Lite graphite-coated wheels and PRO BSA graphite-coated grooved axles.
What kind of saw do you use for Pinewood Derby car?
Band saws are the best tool for cutting a Pinewood Derby car block. If you don’t have access to a band saw, a coping saw will do. Coping saws are economical and can cut unusual shapes and curves.
Does a heavier Pinewood Derby car go faster?
Much has been written about the physics of pinewood derby cars, and this is one rare case in racing where heavy = fast. Aerodynamics have little effect in such a short race, but weight does and putting the weight at the back of the car will make your car faster on the flat of the track.
How can I make my Pinewood Derby wheels faster?
Place all of the weight you can about an inch in front of the rear axle. The closer the weight to the back, the faster your car will roll (but you don’t want it too far back or else your car will be popping a wheelie).
How do you make a Pinewood Derby car go faster?
10 Tips and Tricks to a Fast and Cool-Looking Pinewood Derby Car
- Bake your block.
- Max out your weight at the regulation 5 ounces.
- Use all of the graphite (dry lubricant is usually allowed).
- Sand and polish your wheels and axles.
- Check alignment.
- Spend time on sanding.
- Use a high-quality paint.
- Add decals!
Can I use a jigsaw for a Pinewood Derby car?
A jigsaw works well for cutting out a Pinewood Derby car if you can successfully clamp down the block of wood so that nothing impedes the blade or guide.
How do you cut a Pinewood Derby without a bandsaw?
If you don’t have access to a band saw, a coping saw will do. Coping saws are economical and can cut unusual shapes and curves. Coping Saws are intended for cutting curves in thin material but they can be used for cutting your Pinewood Derby car.
What kind of saw do you need for a Pinewood Derby car?
Band saws
Band saws are the best tool for cutting a Pinewood Derby car block. If you don’t have access to a band saw, a coping saw will do. Coping saws are economical and can cut unusual shapes and curves.
Do heavier Pinewood Derby cars go faster?
Where is the best place to put weights on a Pinewood Derby car?
PUT MOST OF THE WEIGHT IN THE BACK Science says the heaviest part of your car should be about 1 inch in front of the rear axle. The idea is that the farther back the weight is, the more potential energy you have because your center of mass is higher up on the track.
How close should wheels be on pinewood derby car?
The car may be hollowed out and built up to the maximum weight by the addition of wood or metal that is securely fastened to the car body. 7. The wheel base (distance from front axle to the rear axle) may not be altered. The cut slots must be used for the axles and the wheel base distance must be 4-1/4 to 4 3/8 inches.
