What is the transmission fluid capacity?

What is the transmission fluid capacity?

In general, transmissions take about 9 to 13 quarts to fill completely. The amount of transmission you add will vary, depending on whether you are draining or replacing it all or you are just topping it up. Again, you should avoid adding too much. It is advisable to put in little amounts at a time.

What is the difference between 45RFE and 545RFE?

In the 45RFE applications four gears are utilized. In the 545RFE four gears are used on the upshift and a new “gear”, 2nd Prime, was used with a different (1.50:1 rather than 1.67:1) ratio to increase versatility when downshifting. Although, with some tuning, you can get the 545RFE to upshift into 2nd Prime.

How much transmission fluid does a Dodge Durango take?

6 liters
BLAU Dodge Durango ATF Transmission Fluid Change Kit includes: 6 liters of Dodge 68218925AA spec transmission fluid, filter, gasket, hardware and fluid transfer tool.

What happens if I put in too much transmission fluid?

If you overfill it, the transmission will experience hard shifting and slippage. Another consequence of overfilling your transmission is that it will cause the fluid to lose its lubricating properties. It could also lead to the entire system blowing up and not functioning.

What does 45RFE stand for?

Dubbed the 45RFE, the name indicated it had four forward speeds, a relative torque rating of 5, was intended for rear (and four) wheel drive applications, and featured full electronic control.

What cars have a 45RFE transmission?

The 545RFE made its way into Chrysler’s entire fleet of rear-wheel drive trucks, save for sedans and coupes: the Jeep Liberty, Dodge Ram, Dodge Dakota, Dodge Durango, and Jeep Commander.

How many quarts of transmission fluid does a 2013 Dodge Durango take?

A 2013 Dodge Durango transmission flush also uses about 10 quarts of fluid to absolutely clean and flush out the system.

How many quarts of transmission fluid does a Dodge truck take?

15 Answers. 5 qrts oil with filter,5 qrts atf,just with fluid and filter change.

Do I check transmission fluid hot or cold?

Checking Transmission Fluid Levels If you’re going to be checking the transmission fluid level at home, it’s a good idea to warm up the car before you do so. If the car is checked while the engine is cold, it might give an inaccurate reading when you use the dipstick.

What happens if you add too much transmission fluid?

How much torque can the 66RFE handle?

660 ft-lbs
Looks like 660 ft-lbs of torque is what it can handle.