What tools do guy wire anchor tensions use?

What tools do guy wire anchor tensions use?

Guy Wire Fittings

• Guy clamp is used on the communication line.
• Guy thimble is also called cable thimble, and it is accessible on the electric power line or dead-end pole line.
• Pole band is also a fitting utilized together with the guy wire.

How do you check male wire tension?

Direct and indirect are the two common methods of measuring guy tension on towers. The direct method uses mechanical or hydraulic equipment to pull the guy wire to measure the tension with a calibrated gauge. A mechanical dynamometer capable of measuring up to 20,000 lbs. runs approximately $900.00 list.

What can I use for guy wires?

The materials needed for a standard guy wire installation are: guy wires, guy ring(s), screw eye, and turnbuckles. Six-strand 18 or 20 gauge galvanized steel guy wire is recommended for general use(The 18 gauge wire is recommended for high-wind areas and installations over 20 ft. above the uppermost support.).

Why is it called guy wire?

Dutch ships used “gei” (which we now know as guy) as the name of the rope or wire they used to hold the mast or mainsail steady. Appropriately enough, it truly was a wire used as a guide. But the origin was from the French and Dutch, and their term for the tension wire they used to secure their structures.

What angle should guy wires be?

45 degrees
Fortunately, the variables of guy wires are straightforward. The first thing to note is that guy wires should extend at an angle of 45 degrees. The pole being supported is erected at a straight 90 degrees, while the ground offers a flat, horizontal surface.

How do you measure tension on a wire rope?

Keeping the height of the end of the cable the same as at the fixed end, pull on the cable until the weight is completely suspended by the cable. Measure the tension in each end of the cable, the horizontal distance from the weight to the person holding the free end of the cable.