Where do you find the model number on a Jacuzzi bathtub?
Table of Contents
Where do you find the model number on a Jacuzzi bathtub?
The model and serial number is located in three places:
- On a label located on the back page of your Operating/Installation Instructions. (With the warranty information)
- On a white label located on the bath vessel near the pump/motor.
- On the shell under the suction cover. (Rectangular cover/filter inside of bath)
What are the parts of a jet tub?
Jetted Bathtub Parts Jacuzzi Whirlpool Tub Replacement Controls Jets Pump Part
- Commonly Replaced Bathtub Parts. The most common items needing repairs are the air control button to start the bubbles; the motor; and the control panel.
- Air Control Buttons.
- Bathtub Jets.
- Bathtub Accessories and Fragrance.
Can you replace the jets in a whirlpool tub?
To replace spa jets, you’ll need to drain the water from the tub, remove the existing jets, and screw in new jets that fit your tub. You can usually buy new jets from the same company you purchased the tub from.
Can a jetted tub be fixed?
Maintaining a Jetted Tub To remove a jet, all you may need to do is twist it off; however, some jets may require a wrench, while others may have specific instructions, so consult the user manual first. Measure the jets to ensure the replacement is the right size and install it according to the instructions.
How long do Jacuzzi bath tubs last?
The average life expectancy of a whirlpool tub is 20-50 years, according to the Study of Life Expectancy of Home Components, prepared by the National Association of Home Builders.
Why won’t the jets work in my bathtub?
Jets Are Not Working Properly You will need to diagnose hot tub problems relating to the pump. Check your pump’s priming to make sure it is working properly. Open the access panel and the airlock valve close to the pump. This releases air from the line and purge system, allowing more water to stream through the jets.
Why are my bathtub jets not working?
When jets start failing, the most likely case is that your hot tub pump is not working correctly. You will need to diagnose hot tub problems relating to the pump. Check your pump’s priming to make sure it is working properly. Open the access panel and the airlock valve close to the pump.
