Why is my Klipsch subwoofer not working?
Table of Contents
Why is my Klipsch subwoofer not working?
Common Issues Solution: Check to see where the subwoofer is plugged into on the back of the receiver. It needs to be plugged into a dedicated subwoofer, or “sub out”, channel. It’s possible it may be plugged into an RCA port that is not sending any audio or low frequency content.
How do I connect my Klipsch subwoofer to my receiver?
Using a subwoofer cable (RCA cable), connect the subwoofer to the AV receiver by running the cable from the receiver’s subwoofer output to the subwoofer’s line input. Klipsch subwoofers can be connected via the LFE channel, the white RCA connection, or in a stereo pair by using both the white and red RCA connections.
Why did my sub just stop working?
If your subwoofer stopped working, there’s a good chance it was blown. To check, unplug the subwoofer and plug it back in. If it still doesn’t work, try switching the input from AUX to SUBWOOFER on the amp. If that doesn’t work, the subwoofer is probably blown and needs to be replaced.
How do you fix a subwoofer that won’t turn on?
If the subwoofer still doesn’t power on, try plugging it into a different outlet that you know works properly. As with the speaker wires, inspect the subwoofer’s power cable for any damage or defects. Some subwoofers are equipped with a fuse, which may or may not require removal of a back plate.
How do you troubleshoot a powered subwoofer?
Ensure the subwoofer has not been muted. Increase the volume level on the subwoofer. Ensure the speaker settings on the stereo system or TV have been configured properly to use the subwoofer. IMPORTANT: Certain speaker settings may disable the subwoofer.
Can you hook up subwoofer without amp?
In nearly all cases, the answer is yes. Unless you have a system in your car or boat that is already powering a subwoofer, you’ll need to find an amplifier that will power your sub. Your head unit will typically provide a low-power signal (RCA output) that can be used for an amplifier to power your subwoofer.
How do I reset my Klipsch subwoofer?
The Three – Factory Reset
- Disconnect the power cable from the speaker and wall outlet.
- Plug the power cable back into the wall outlet.
- Press and hold down the source select knob on top of the speaker.
- While holding, plug the power cable into the back of the speaker.
- The speaker has been reset.
What is LFE on Klipsch subwoofer?
If you are controlling the crossover point within your receiver or pre-amp, you will turn this knob all the way to the right. Most of our powered subwoofers will have this point labeled as “LFE”. RCA Inputs (L/LFE & R): This is where you will plug in your single RCA or subwoofer cable.
What causes a sub to stop working?
Short Circuit The most common cause of speaker failure is short-circuiting. A short circuit in the wires providing the signal will prevent the signal from ever reaching the subwoofer. A short circuit at the terminals on the subwoofer will also prevent electrical current and signal from reaching the subwoofer.
Why would my sub just stop working?
Can a subwoofer be repaired?
Can you fix a blown subwoofer? Yes, you can fix a blown subwoofer especially when it is partially blown sub damaged cone. However, a damaged voice coil will be difficult to replace. Depending on the extent of the problem, the best solution is to purchase a new subwoofer.
