Do I need furring strips for basement ceiling?
Table of Contents
Do I need furring strips for basement ceiling?
If you’re hanging drywall on new ceiling joists, you probably won’t need furring strips. Standard drywall panels attach directly to the joists with drywall screws. If the ceiling is old, however, and you don’t want to remove the existing ceiling finish, furring strips can provide a solid base.
Can you attach drywall to ceiling furring strips?
Once the furring strips are in place, you can install the drywall the same way you would on any stud wall. For a standard 8-foot high wall, start by installing a sheet of drywall horizontally at the top edge of the wall, using drywall screws inserted every 8 inches into the furring strips.
Why are there furring strips on the ceiling?
Furring strips are used to provide carpenters a level and supportive structure when they’re applying the finish. Whether it’s the ceiling or the walls, furring strips are essential to ensuring that you’ll always get a flat and smooth surface when the project is complete.
How do you install furring strips on a drywall ceiling?
How to Attach Furring Strips to Ceiling Joists
- Locate and mark the position of joists in the ceiling.
- Calculate the size and spacing needed for the furring strips.
- Place the first strip at the perimeter of the wall.
- Install the next furring strip parallel to the first.
- Install additional furring strips as needed.
Can you put drywall directly on basement ceiling joists?
Yes you can, but it is not always easy to do. The joists may not be perfectly spaced and you only have a 1-1/2 inch target for attaching two edges of the drywall.
Should I Nail or screw furring strips?
If you HAVE to run furring strips rather than building a wall, definitely go with mechanical fasteners (i.e tapcon screws — avoid concrete nails). Construction adhesive is not made for a “structural application” such as bonding 2×4’s to a concrete wall.
Should you nail or screw furring strips?
For furring strip installation, affix the strips across the joists every 24” on center with screws or nails at least 1” long so that they will go into the joist with a minimum depth of 1/4″. Use shims, if necessary, to achieve a uniform flat and level ceiling or wall.
How far apart should furring strips be for drywall?
Most builders keep furring strips 16-inch apart for siding, 16 or 24-inch apart for a metal roof, and about 8 to 10 inches apart for drywall.
Can you use 1/2 drywall basement ceiling?
Drywall Size – Basement Drywall Thickness The most commonly installed thickness, per my extensive Google searching, is 1/2 inch. This is what I had installed in my basement. I considered 3/4 of an inch, especially for the ceiling and some of the walls where I wanted to cut down on noise transfer.
How do you attach furring strips to concrete ceiling?
Use a hammer drill, drill holes using the correct diameter carbide-tipped masonry bit for the concrete screw diameter in use. Drill the masonry hole 1/2 deeper than the fastener embedment. Vacuum holes of masonry dust. Drive the Tapcon screws into the holes of furring strips with an impact driver and nut driver.
Do you nail or screw furring strips?
Do you need to use green board in a basement?
Green board is intended for use for ordinary wall applications in areas that experience constant high humidity, such as bathrooms and basements, but it does not have the superior mold-resistance of newer products.
Do I need mold-resistant drywall in a dry basement?
Nor will it prevent mold in the case of flooding, when water saturates the drywall and the organic wood framing behind it. But in rooms that experience frequent humidity and are often subject to mold and mildew, such as bathrooms or basements, mold-resistant drywall is a good choice.
