How do I configure a master and slave hard drive?
Table of Contents
How do I configure a master and slave hard drive?
Using the arrow keys, find and select the hard drive that you attached to the computer. Change the hard drive to “Slave” status. You’ll use the “Configure” or “Change” key to do this as well. Once you see “Slave” to the right (or near) the drive’s name, you can proceed.
What are the 4 pins on my hard drive?
A jumper pin is a rectangular connector that creates a circuit between two pins. Seagate SATA drives have four pins, while Western Digital SATA drives have eight pins, with the additional pins to be used by technicians or your network administrator for powering up the drive while in standby mode.
What is master and slave in hard disk?
In electronics, master/slave relationships are used to describe some of the following scenarios: In parallel ATA hard drive arrangements, the terms master and slave are used to describe drives on the same cable, but neither drive has control or priority over the other.
What are the pins on the back of a HDD for?
You may have pins on the back of your hard drive that nothing is connected to. These pins are called jumpers, and are used to enable specific types of settings. They’re not used so much with modern hard drives, except in some special circumstances.
What is a master slave configuration?
Nearly all current surgical robotic systems employ a master–slave configuration, where the surgeon uses joystick-like controls at the master console to direct the movements of the robotic instruments (slave).
What is the number of pins in a SATA 2.5 drive?
2.5″ SATA SSD and Slim SATA (MO-297) Connector There are a total of 22-pins broken into 7-pins for Data and 15-pins for Power.
What is master-slave configuration?
What are the 8 pins on HDD?
They’re actually jumper pins. You may enable particular settings by placing a jumper shunt onto specific pins—creating an electrical circuit between them. The settings these jumpers enable are hard-coded onto a drive’s programmed printed circuit board.
Which port is used to master and slave configuration?
The slave port is a parallel communication port that can be used to communicate with an external master device….18.1 Overview.
| Slave Port Address | Slave Port Register |
|---|---|
| 11 | Status Register |
What is slave configuration?
How do I slave a SATA hard drive?
Plug one end of a SATA data cable into the smaller L-shaped connector on the hard drive, and plug the other end into one of the SATA controllers on your computer’s motherboard. The SATA controllers are usually labeled SATA1, SATA2 and so on.
How do I setup a slave computer?
Setting Up Easy Connect (Slave Computer)
- Move the mouse cursor to the upper-right corner of the screen and click Search when the menu appears.
- Type “Windows Remote Assistance” in the search field, click Apps and then click Windows Remote Assistance.
- Click “Invite someone you trust to help you.”
- Click “Use Easy Connect.”
How many pins does a SATA data cable have?
seven pins
As previously mentioned, SATA data connectors typically feature seven pins – explained in the chart below. In a standard assembly, one end of the cable will be connected to the hard drive, while the other will be connected to the motherboard.
How many pins are in SATA connection?
Is the disadvantage of master-slave configuration?
The disadvantages include: It is as reliable as a single processor system, i.e., if the master processor fails the entire system fails. It creates more overhead charges. There would be situations when the slave processors would be free before the master processor could assign them another task.
