Helpful tips

How do I debug PHPMailer?

How do I debug PHPMailer?

Enable SMTP debugging and set the debug level in your script as follows: $mail->SMTPDebug = 2; level 1 = client; will show you messages sent by the client. level 2 = client and server; will add server messages, it’s the recommended setting.

How do I stop emails going to spam in PHPMailer?

usually this happens because the sending server is already marked as spam by somebody. The way i found is go to the gmail account mark the item as ‘important’ in gmail and ‘Add to Safe senders’ in Outlook.

How do I install the latest PHPMailer?

Installing PHPMailer

  1. Log into your server via SSH.
  2. Make sure you’re in your user’s home directory. [server]$ cd ~
  3. Unzip the file. [server]$ unzip master.zip. This creates a directory named PHPMailer-master.
  4. Rename this directory. [server]$ mv PHPMailer-master PHPMailer.

Why does Phpmailer go to spam?

What is the common problem occurs when using SMTP mailing list in PHP?

Check for Port connection failure Port block is a very common problem which most developers face while integrating their code to deliver emails using SMTP.

How do I troubleshoot SMTP problems?

Solution

  1. Check the SMTP server settings. SMTP server address—Check the host name or network address of the SMTP e-mail server.
  2. Check the SMTP authentication settings. Check whether the e-mail server requires authentication.
  3. Test SMTP settings by sending a test e-mail. If you are unable to send a test e-mail:

How do I troubleshoot SMTP error?

What should I do if my emails go to spam?

All you will need to do is:

  1. Send a message (exactly the same that you would like to send to a client or another recipient) to the temporary address indicated on the screen.
  2. Follow the recommendations.

How do I test my SMTP server?

To test the SMTP service, follow these steps:

  1. On a client computer running Windows Server or Windows 10 (with telnet client installed), type. Telnet at a command prompt, and then press ENTER.
  2. At the telnet prompt, type set LocalEcho, press ENTER, and then type open 25, and then press ENTER.
  • September 8, 2022

You may also like...