How do you install fiberon stair railings?

How do you install fiberon stair railings?

Insert the upper and lower top stair brackets (FF and HH) onto the top rails. Insert the upper and lower bottom stair brackets (GG and II) onto the bottom rails. Place the lower rail and brackets in place, and locate and mark the screw holes. Remove the rail and brackets, and pre-drill with a 1/8-in.

Can you cut fiberon railing?

NOTE: Rail lengths will vary slightly due to manufacturing processes. Make sure rails are cut properly to correct length, and with hole pattern centered between posts before securing. Cut bottom rail to proper length, then align the hole pattern with the top rail and transfer the cut angle.

How do you finish the ends of Fiberon decking?

Composite decking ends can be finished by picture framing, raised fascia board, painting the ends, attaching decking veneer, composite nosing strips, vinyl stair nosing cove, composite corner trim or plastic end caps. In short composite decking, ends must be hidden or blended into the look of the decking boards.

How high should a handrail be on deck stairs?

between 34 inches and 38 inches high
Stair rails on decks should be between 34 inches and 38 inches high, measured vertically from the nose of the tread to the top of the rail. Treads must be at least 10 inches deep, measuring from front to back.

What do you use to cut vinyl railings?

Vinyl railing is generally soft enough to cut with most general purpose blades. The best blades for cutting vinyl railing are carbide tip blades. These can be found in several forms including hacksaws for manual cutting and circular saws.

How do you hide the ends of composite decking?

Install Fascia Boards Installing fascia boards is a common practice to hide the ends of composite decking boards. Like picture framing, it gives the decking a stylish and sleek look while hiding the exposed ends. The difference is that you will install it on the sides, directly over the edges and the rim joists.