Is Aquabot out of business?
Table of Contents
Is Aquabot out of business?
2020: Fluidra/Zodiac discontinues all production of the Aquaproducts (US assembled) line of cleaners and related repair parts and closes the New Jersey factory. The remaining stock of parts is now being shipped from a third party fulfillment warehouse until supply has been exhausted.
How do I reset my Aquabot?
Switch the Power Supply “Off” and “On” several times, allowing approximately 30 seconds between each“ON” and “OFF”. Remember, if your Aquabot comes equipped with a Reset Switch it must be pressed each time after pressing the “ON” button.
How many drive belts does an Aquabot have?
Single drive motor cleaners like the Aquabot Classic, Turbo, Jr and T2 have one pair of belts (on one side) to transfer power from the motor and rotate the drive system, while RC equipped dual drive motor cleaners like the T4 (and some with a vibrating brush on the bottom) have belts on both sides.
How do you troubleshoot Aquabot?
Aquabot Troubleshooting
- Check if your indicator light is glowing on the transformer. If not, be sure that the 3 volt indicator fuse is not blown.
- Check that unit is receiving power while underwater. Is water flowing out from the outlet on top of unit?
- Are the drive belts tight and not worn?
Why is my Hayward pool cleaner floating?
Cleaner floats above the pool floor. The cleaner is heavier than water, and should not float. Ensure that all the air was removed from the cleaner head and hoses during installation. Make sure that the hose extends two full sections past the furthest point in the pool.
Why is my Aquabot pool cleaner not moving?
a) Check to make sure that no debris is caught on the drive belt or the drive tracks. b) Check to make sure drive belts are not worn or broken on your Aquabot Machine. Also, be sure belts are tight. c) Check to be sure the larger drive tracks are not loose or in the wrong place.
Why is my pool cleaner always on its side?
Cleaner keeps falling on its side. Check to make ensure that the hose connected to the head is the leader hose (the section of hose with the grey cuff). A connector hose attached at this point can cause this situation. Check to make sure the leader hose is in good condition. Hold the leader hose by one end.
