What is L1 and L2 on a wiring diagram?
Table of Contents
What is L1 and L2 on a wiring diagram?
The incoming circuit wires that provide the power are referred to as the line wires. L1 (line 1) is a red wire and L2 (line 2) is a black wire. Together, they show the motor voltage. Having both an L1 and L2 indicate that the motor voltage may be 240 volts.
What happens if you hook a starter up backwards?
When reversing the wires, most starters change the fields to cause the motor to spin in the same direction. It is difficult to connect the positive wire from the battery to the negative of the starter, so you have to make a short circuit.
Is L1 and L2 the same as 1 way and 2 way?
Wiring a One Way Switch The other terminal is marked as L1 and is the output to the light fixture. When you’re wiring decorative light switches such as chrome or stainless steel etc, you’ll find that the switch will also have an L2 terminal which means it’s a two way switch.
What is A1 and A2 on a contactor?
What Do A1 and A2 Mean on a Contactor? A1 and A2 on a contactor typically refer to either end of the electromagnetic coil assembly. Most contactor manufacturers use A1 and A2 to designate the two terminals connecting electrical power to the contactor’s magnetic coil.
How does a single phase motor starter work?
Single phase motors work on the same principle as 3 phase motors except they are only run off one phase. A single phase sets up an oscillating magnetic field that goes back and forth rather than a rotating magnetic field (see bottom figure). Because of this a true single phase motor has zero starting torque.
Which wire goes where on a starter?
The negative (ground) cable connects the negative “-” battery terminal to the engine cylinder block, or transmission, close to the starter. The positive cable connects the positive “+” battery terminal to the starter solenoid.
Does the blue wire go in L1 or L2?
The yellow wire goes into the common terminal, red goes into the L1 terminal and blue goes into the L2 terminal.
What Colour wire goes in L2?
US AC power circuit wiring color codes
| Function | label | Color, common |
|---|---|---|
| Neutral | N | white |
| Line, single phase | L | black or red (2nd hot) |
| Line, 3-phase | L1 | black |
| Line, 3-phase | L2 | red |
How does a 3 phase motor starter work?
It uses a solenoid to electromechanically engage (by generating linear motion) all three power-switching contacts simultaneously when the coil is energized. The linear motion of the solenoid coil in the three-pole electromagnetic motor starter replaces the handle of the switch used in the three-pole manual starter.
