What is the minimum breaking strength of control lines?

What is the minimum breaking strength of control lines?

200 pounds
OSHA’s intent, therefore, is for control lines to serve mainly as a visual warning rather than a rigid, physical barricade. Appendix D does, however, recommend that control lines have a minimum breaking strength of 200 pounds.

What is the maximum free fall distance allowed for a worker using a positioning system?

6 feet
A positioning-device system provides support and must stop a free fall within 2 feet; a personal-fall-arrest system provides no support and must limit free-fall distance to 6 feet.

What is the OSHA regulation regarding earthmoving or compacting equipment to be used in reverse gear?

No employer shall permit earthmoving or compacting equipment which has an obstructed view to the rear to be used in reverse gear unless the equipment has in operation a reverse signal alarm distinguishable from the surrounding noise level or an employee signals that it is safe to do so.

How close can you work to an unprotected edge?

Each employee on a walking/working surface (horizontal and vertical surface) with an unprotected side or edge which is 6 feet (1.8 m) or more above a lower level shall be protected from falling by the use of guardrail systems, safety net systems, or personal fall arrest systems.

What are the requirements for working in a CDZ?

Controlled Decking Zone (CDZ) Leading-edge workers in a CDZ are required to: Be protected from fall hazards above 2 stories or 30 feet (whichever is less). Have completed CDZ training in accordance with 29 CFR 1926.761.

Is fall protection required at 4 feet?

The employer must ensure each employee on a runway or similar walkway is protected from falling 4 feet (1.2 m) or more to a lower level by a guardrail system. Each employee is provided with and uses a personal fall arrest system or travel restraint system.

What is the maximum deceleration distance allowed by OSHA?

3.5 ft
Personal fall arrest systems must bring the employee to a complete stop and limit the maximum deceleration distance the employee travels to 3.5 ft (1.1 m).

Are backup beepers required?

Backup alarms are required on all vehicles operated on off-highway job sites. Some chassis manufacturers use their backup lights as perimeter lighting when exiting the vehicle at night. This can cause issues when connecting the backup alarm to the reverse lights.

What does OSHA consider a leading edge?

In the Safety and Health Regulations for Construction, CFR 1926 Subpart R, OSHA defines a leading edge as “the unprotected side and edge of a floor, roof, or formwork for a floor or other walking/working surface (such as deck) which changes location as additional floor, roof, decking or formwork sections are placed.

At what depth of a trench does OSHA require fall protection?

Trenches 5 feet (1.5 meters) deep or greater require a protective system unless the excavation is made entirely in stable rock. If less than 5 feet deep, a competent person may determine that a protective system is not required.

What is the minimum height for fall protection for connectors?

30 feet
Overhead Hazards Connectors must: Be protected by conventional fall protection when working on a surface with an unprotected edge more than two stories or 30 feet above a lower level.

What is work at height as per OSHA?

Working at Heights — Any work at height of 1.8 meter or more from the ground level or floor. Elevated working positions where the hazard of a fall exists and where there is no physical protection such as handrails.

What is free fall distance?

Free fall or free fall distance – the distance before the fall arrest system begins to apply force and slow the worker down or arrest the fall. According to OSHA standards, this distance shouldn’t be more than 6 feet (1.8 meters) and it depends on lanyard length and where the attachment point is located.

What is the maximum free fall distance when wearing a full body harness with a 6 foot lanyard?

The distance, which you fall before the fall protection system begins to slow you down. According to OSHA standards, this distance should never be more than 1,8 meters (6 ft) and is based on the length of the lanyard and the location of the attachment point of the harness where the lanyard is attached to.

What does OSHA require all vehicles to be equipped with?

All vehicles shall have a service brake system, an emergency brake system, and a parking brake system. These systems may use common components, and shall be maintained in operable condition.