Why does my Braun thermometer say err?
Table of Contents
Why does my Braun thermometer say err?
Question: What should I do if my thermometer is displaying an Err message? Answer: This message displays when measured temperature is lower than 93.9 °F (34.4 °C) or higher than 108 °F (42.2 °C). Please make sure the protective cap is removed from the unit and Re-measure the temperature again.
Why is my Braun Thermoscan not working?
Answer: A flashing display indicates a system error. We suggest waiting 1 minute until the thermometer turns off by itself and then turns on again. If the problem persists, reset the thermometer by removing the batteries momentarily.
How do you fix an err on a thermometer?
Remove the battery and clear the compartment of anything that could prevent the battery from making a good connection, like dirt or debris. Clean out any dirt with a dry cotton swab. Place the battery back inside of your thermometer, making sure the shinier, more reflective side is facing up. Replace the battery cover.
What does ER 1 mean on a thermometer?
The error messages that may appear on a display are as follows: Er1 is indicated when temperature of the ear thermometer is outside the specified operating ambient temperature range. The thermometer itself is either too cold or too warm for normal functioning.
What does err mean on a digital thermometer?
there is a malfunction
Updated on 2017-04-07. The ‘Err’ indication can be displayed on both the digital flexible tip thermometer and on the soother thermometer. This means there is a malfunction.
How do I fix my Braun Thermoscan POS error?
System Error – Wait 1 minute until the thermometer turns off automatically, then turn on again. If error persists reset the thermometer by removing the batteries and putting them back in. If error still persists contact your Welch Allyn representative. Insert new batteries.
Why does my Braun thermometer keep flashing?
If the thermometer is unstable or patient is moving during the measuring process, the device will beep, the green ExacTemp light will flash and POS (Position Error) will flash on the display. Be sure the device is stable and restrict patient movement for the next measurement. Change the probe cover to reset.
How do you fix a high error on a digital thermometer?
Resetting ‘Err’
- Press the on/off button to switch off the flexible tip or soother thermometer, then press the on/off button again to switch on the thermometer.
- Proceed as usual in measuring the temperature.
What does ERL mean on thermometer?
The error message “Er.L” indicates that the current temperature in the operating environment is too. low (below 10°C).
What batteries does a Braun ThermoScan take?
Replacement Batteries For Braun ThermoScan 3 Ear Thermometer – 2 X (CR2032) Replacement Batteries For Braun ThermoScan 3 Ear Thermo…