Can you use PEX for ice maker?
Table of Contents
Can you use PEX for ice maker?
The Everbilt PEX ice maker supply line is designed to connect the water supply to your icemaker and it’s an approved alternative to copper lines. The connector is built with PEX for better tasting ice and water.
Can you use a self piercing saddle valve on PEX?
Most saddle valves are designed to work with standard rigid copper pipes—they are not recommended for PVC, CPVC, or PEX plastic pipe. They are also designed for water systems with a maximum pressure of no more than 125 psi.
How high should an icemaker box be?
4 feet is a good height. Don’t put it to low.
Can I use plastic tubing for ice maker?
Answer: You’re right to be concerned, because plastic tubing to an ice maker is susceptible to cracking and splitting. The constant flow of hot air from the compressor fan in the essentially unventilated space behind the fridge blows over and around the tubing — and eventually makes it quite brittle.
Are saddle valves legal?
Answer. Most state and local codes prohibit the use of a saddle valve, also known as a piercing saddle valve, saddle tap or needle valve, consisting of a clamp that punctures a hole in an existing water intake pipe. It is a shortcut used instead of installing a more permanent and secure connection.
Can you put a saddle valve on PEX?
Can you use hot water line for icemaker?
Just use cold water and be done with it. If you use hot water, you will lose capacity. the small amount of water going into a domestic fridge ice maker would probably be room temperature just from sitting in the line waiting to be used whether hooked to hot or cold.
Can you mount ice maker box upside down?
Yes, any of the ice maker or specialty boxes can be converted to a Top Mount application by turning the box upside down – in fact, they can be installed at any angle.
What type of tubing is used for a refrigerator water line?
The tubing should have a diameter of 1/4-inch and can be copper line, braided steel line or plastic tubing. Many professionals prefer copper line, but plastic tubing is commonly sold as part of ice maker installation kits.
