How do I reset my Napco Security system?

How do I reset my Napco Security system?

Press reset to clear trouble. If this does not work, enter your code and press the function key until the reset menu comes up. Press the ON/OFF key. When “reset system trouble” appears, press ON/OFF again, and then press the RESET key until screen is normal.

How do you bypass a Magnum alert?

BYPASS: Press the B/A key then the 2 digit zone number to be bypassed. CHIME: Hold 5 until keypad beeps. TO ARM SYSTEM WHEN LEAVING: Enter code and leave.

What does P mean on alarm system?

The letter “P” in the window upon power up indicates the control panel is attempting to power up into the Armed state, but is unable to do so (likely due to open zones or a system trouble). Enter your Arm / Disarm code on the next power up attempt, and the system will disarm.

How do I remove a Napco keypad?

Mounting the Keypad To remove the keypad from the backplate, insert a small screwdriver into the slots at the bottom of the keypad. Pull up on the screwdriver to pop off the cover.

How do you arm and disarm a Napco Security system?

To arm all areas simultaneously, press 9, G and enter your code followed by J. To disarm all areas simultaneously, press 0, G and enter your code followed by J.

How do you arm a Napco Alarm?

  1. 1 Check the keypad for a SYSTEM READY message. The green STATUS light. must be on in order to arm. The window will display —SYSTEM READY“.
  2. 2 Arm the system. ❑ Enter your User Code and press >. ❑
  3. 3 Leave the premises. Leave through the exit door before exit time expires.

What does OC mean on an alarm?

OPEN CIRCUIT (or OC): The Keypad is not communicating with the main control panel.

What is a DT alarm?

Dual Technology (DT), also called ‘Dualtec’ detectors, comprise a PIR and a Microwave detector in the same unit. The basic operation of these detectors are that both elements within the detector have to be triggered to create an alarm activation.

What does FC on ADT mean?

One of the most common error codes that show on ADT alarm systems is the ADT error code FC. In the alarm system, ‘FC’ stands for ‘Failed Communication’ and indicates that the system is not communicated well with the monitoring company.

What is a Rio on an intruder alarm?

RIO (Remote Input/Output) expansion module.

  • October 11, 2022