How do you start a montigo gas fireplace?
Table of Contents
How do you start a montigo gas fireplace?
a) Partially depress and turn dial on gas control valve to “OFF” position and wait 5 minutes. b) Turn dial to pilot position, depress dial and light pilot burner, hold for 1 minute, then release. If pilot does not remain ignited, repeat, allowing a longer time to elapse before releasing dial.
Do montigo fireplaces give off heat?
A: No, commercially minded fireplaces are decorative appliances only and do not provide any heat to the room.
What is DV gas fireplace?
A direct vent fireplace has a completely sealed combustion chamber which allows it to vent directly out a side wall or through the ceiling of your home. A direct vent fireplace uses the natural principal of warm air rising to create negative pressure in the system to draw in cold air for combustion.
How do you redirect heat from a gas fireplace?
Draw heat from the fireplace to another room in the home, up to 20 feet away. When a Heat-Zone kit is run continuously, it can redirect up to 25% of the heat to another area, also reducing wall temperatures above the fireplace. Two Heat-Zones run continuously will redirect up to 50% of the total heat output.
Do gas fireplaces have real flames?
The natural look of real flames A gas fireplace has real flames, and this is simply not a possibility with electric units. With gas fireplaces you can also choose the type of material beneath the flames, with styles ranging from realistic driftwood to modern glass or stones.
What is AB vent for a gas fireplace?
B vent: This approach, also called natural vent, pulls air from indoors for combustion and vents it outside. It features a chimney with a double wall pipe which runs from the fireplace to outside of the home. Homeowners can purchase fire boxes inside another box.
How do I reset my Proflame remote?
Reset Using the Transmitter ON/OFF power button: Turn the system off by pressing the remote power button. After approximately 2 seconds press it again. Reset Using the Remote Flame Adjustment buttons: In the manual mode, use the down arrow to lower the flame all the way to OFF.
Why is my fireplace switch not working?
What can happen over the years, is that the connections inside the switch can get dirty, corroded, or broken, causing a loss of this voltage at the switch. So by the time the small amount of voltage gets sent back to the fireplace, it is not enough to signal the fireplace to turn on.
Why does my gas fireplace not heat the room?
Gas fireplaces do not fully heat a room if the type of system or BTU rating is inadequate for the space that they are in. Solutions such as blowers, gas inserts, and heat exchangers can be used to optimize the heat released from a gas fireplace.
Why is my fireplace not heating my house?
Use the Damper to Turn Up the Heat Make sure to fully open the damper when starting the fire. When you have a great fire going, slightly close the damper to prevent excess heat from escaping. If the room still isn’t warm enough, close the damper a little bit more. This will enhance your heating output.
Why wont my gas fireplace heat up?
Do gas fireplaces need to be cleaned?
While gas fireplaces don’t produce creosote, they do still need annual cleaning. Both propane and natural gas are clean burning gas fuels, so they don’t produce the same byproducts as wood, but they can still produce buildup that needs to be cleaned away.
